biosp Auto Mud Flaps Splash Guards For Ford Escape 2013 2014 2015 2016 2017 2018 2019 Front and Rear Fender Cover PP-Custom Fit Black Molded 4Pcs Set

Fit nice and tight, easy to install. Use your factory push pins in the front for the lower three holes and one of the supplied screws for the top hole. You will need to drill a small pilot hole for the additional screw. For the rears just reuse the factory hardware that’s already there.

These fit as good or better than I was hoping. Easy install, No drilling, finagling, or removing wheels. extremely durable Wide enough to keep snow, sand and sludge from destroying the rocker panels of your car. 2014 Ford Escape. Good product.

I bought this to replace my mud guard on my Ford escape. They were a "close fit" but not perfect. With some shaping and pressing on the rocker panel curvature I was able to fasten them to an almost perfect fit. The cost was a fraction of Ford OEMs so I am very satisfied.

Front flaps didn't have metal clips to put the screws into so I had to put it into plastic. Back ones were fine.

Fit is pretty good, you could probably pretty easily get these on even with tires on, but I did it when I had all 4 off (replacing the lug nuts), and the car up in the air. At that point, it is as pleasant as a menial task can be.

This is the third set of these I have bought. Replaced Weather Tech with these due to front ones falling off on two cars. Installed this set on new car. Have been happy with the previous sets and I am sure this set will be great also. Half the price of Weather Tech mud flaps.

I used the mud flaps to help keep mud off the running boards.

For as cheap as they are they fit amazingly and work well. I used a hair dryer on one part that wasnt *perfectly* aligned to bend it until it was. Again, I'd rather do that than spend 2c as much fron weathertec.