Legines 45 Degree Street Elbow 1/8" NPT Male x 1/8" NPT Female Brass Pipe Fitting (Pack of 2)

Quality workmanship! Fit perfectly!

Greetings. These were used to reconfigure a propane manifold so that two separate propane regulator and hose sets can be operated from the same propane tank at the same time. These fittings appear to be made from brass bar stock, though that is not explicitly stated in the description. The fittings are properly machined and worked very well. The square bar stock surfaces gave a great place to place a wrench to tighten them into place. The threading was smooth with no burrs or rough surfaces. These parts worked well.

I built an outlet manifold for supplying air at the front of my shop/garage, and this allowed me to kick the industrial coupler that was attached to the vertical tee on the pipe that came down from the filter that started out the manifold out at the same 45 degree downward angle to match the rest of the tees that were mounted horizontally from that initial tee.I wanted the couplers to be easier to attach to than if they would be if they were mounted pointing straight down, but didn't want them coming out at a 90 from the wall as that would cause undue stress on the couplers and hoses that would be attached to them. A 45 degree downward angle seemed just right, and this fitting allowed me to do that on the one tee that was mounted vertically that started off the manifold.

The fitting was great but me being a dummy I didn't know the difference between a steet thread and a compression thread

These are the perfect items I needed to restore the gas fuel filter line on my classic car to factory appearance.

Used it to angle my regulator gauge so you could see it under the sand blasting cabinet. Worked well!

need this for my shop tank to get my filter at the right angle, worked great

Good stuff

de bonne qualité merci !