RugooSpink Build Plate for Kobra 3/Kobra 3 V2 Combo 256x268MM Plate (Kaleidoscope+ Dazzle Color) Dual Sided Build Plate Smooth H1H Platform Build Sheet Removable Heated Bed for Anycubic 3D Printer

These build plates are Amazing! I replaced my PEI plates on my Kobra 3 Combo's and I am so happy I did! These are sized to fit perfectly and are reversible. The adhesion is great as long as you keep it clean. I use Dawn dish soap and water and then wipe them with 90% IPA. Allow your print to cool and it will pop right off with a slight bend of the plate! The notches make lining it back up a breeze. They seem to be holding up well as I run them on both my K3C's. I will be buying these again as to be swap-able and save me time between prints. They also leave a cool pattern on the bottom of print, but I'm more into how well my print sticks to it during a print.

I love the double sided function with two different designs, the bottom of the prints come out with the design and it was so amazing! Prints stick very well so far, I’ve had little to no problems with detaching prints. Definitely worth the buy!

Really like the design on the printed parts this plate produces. There is a learning curve on these type plates though. Have to slow first layer down significantly and plat with heated bed temps. Once figured out prints greast !!

Make sure you wash it with soap and water before using. I some how failed to see this very needed step. I used before washing and nothing stuck. Went back and researched, saw the tip on washing with soap and water. After hand washing it, this build sheet works great, I don’t have to crank the bed temp to get graat adhesion. I can also extrude the filament at higher temps without issue. Result is smoother layers with excellent adhesion. Very much recommended.

nice plates, all my prints come out smooth when using these plates. Also design transfers onto plastic. Highly recommend