MGM Switchview 1615SV Burris XTR Tactical Series Scope Magnification Lever

Put this on a Burris x-tac 1.5x6 because the magnification ring was so rigid I could barely budge it with my bare hand. The lever fits well, does what it is supposed, which is to make moving between magnification much easier.It is a quality product machined out of quality material, BUT, way too expensive for what it is in my opinion. I will be more careful in the future to buy scopes with easier magnification rings, so I do not have buy another one of these.

I have two other Switchviews for other scopes and have had zero issues with them. This one is the same great quality, but I did find the cap screws were too short for my XTR. If you find yourself in the same situation, I hit an Ace Hardware store and found the #2 cap screw was the required size/thread for the replacement. Note it is NOT the M2 (metric), but the #2 cap screw. I went just one size longer than the one supplied (don't recall the length) and it worked great.Would have been a 5 star but having to find the cap screws cost it one star on this purchase.

eh... wish there was a bitter product out there for this..

Needed trimming but seems to work!!

Works well on Burris XTR 312. There is a small gap between where the ring mates to the lever. According to the instructions, this is normal and should not be overtightened. Works very well for it's intended use.

Does not fit my Burris XTR II. NOT EVEN CLOSE.

Good product & Fast delivery!!! This fit my Nikon M-223 2-8x32 scope nicely. Makes for much easier Mag adjustments on the scope. I won't put another scope on a rifle without one of these....

Not remotely the correct size for a Burris MTAC 1-4x. Photo included shows approximately 1/2 inch gap.