Advance Ignition Upgraded Set 4PCS Inside Door Handle Tan Chrome Bolt Compatible with Jeep 06-10 Commander 2006 2007 2008 2009 2010

Fitment was perfect and it comes with 4 of the "demolition" bits for your drill. May need slightly longer screws depending on how much/little you knock down the factory melt rivets. Color is very close would have to look pretty closely to notice the difference. So far they seem to work very well. The clip for the latch rod on these are made from a softer compound that your original equipment which is a good thing (less likely to crack or shatter). Installation is a breeze if you have the tools needed and the patience. Be sure to lay your door panel on a solid level surface when you are grinding down the melt rivets with the demolition bit but do not apply too much pressure as you do not want to grind beyond the melted flare, try to grind flush with the old bracket than use a flat head screw driver to break away your old handle's bracket to preserve as much of the melt rivet as possible so that the screws have enough material to grab. Use a regular phillips screw driver to fasten the new handles to your door panels and tighten to a very light torque. DO NOT USE A DRILL! You will ream out the screw holes. This is a finesse job, a heavy hand is not required at all so if you are like me (strong handed), you'll need to be extra gentle screwing the new brackets down. 😉

Pretty good product for the money. Not bad of an install process.. about an hour total.

This product fit perfectly, was easy to install and matched my interior to the tee.