Loctite 1804409 Fixing Press Block product concerned assembled Premium 648, Green, 5 ml

Good

Perfect

Genuine product. was recommended by Loctite HQ themselves when I called them for advice. I had used motorcycle OZ alloy wheels for my motorbike probably about 8 years old or so. Go them powder coated to find the new genuine bearings would just slip in. there was no issue with the bearing housing and confirmed they were the right bearings. Used feeler gauge, the lowest I had was 0.003mm which still wouldnt get through the gap so called Loctite HQ. they recommended to use this. ordered it from Amazon as I needed it quickly. applied a little by hand its not very thick and a bit runny so used my finger to coat it on bearing and in the housing and drove the bearing home. gave it a few spins and in a few it locked in place now rock solid. any squeeze out was minimal and will come off with a towel. it only cures when two metals are in close contact and all the air is expelled from the gap. It has filling capability so if you need something to fill and hold I think this one does upto 0.25mm but you can check the Heckel / Loctite website to see what suits. 10ml did 4 bearings still plenty to spare. shelf life I think is 12 months. Shall report back once wheels are all done and fitted back on the bike if they fail. I highly doubt but shall see, I am skeptical yes but I am a bit more confident after the manufacturer has heard the application and recommended the product. P,S: stinks like strong vinegar like.

Works as it should

Used to install the bearings on my mountain bike rear suspension pivot points. Worked really well.. for best results leave for 24hrs so it bonds hard.

Great stuff. Just what I needed.

Worked perfectly.

Réparation vis de fixation boitier mécanique il a fait se qu'on lui a demandé fixer vis parfaitement et fortement

Het staat erom bekend en dat maakt het ook waar. Voor als het echt goed vast moet.

Schnelle Lieferung

Tudo OK

Nulla da eccepire.