Polyurethane Windshield Adhesive with Fast Curing Formula - High Bond Strength Window Sealant Compound - Easy to Apply Automotive Glass Glue - Windshield Sealant Black - Vehicle & RV Polyurethane Glue

Works well and hardens up nicely. Very sticky and difficult to clean but that's the reason you buy this stuff. I used it to fill up to 3/4" gaps around the rear hatch glass on a 1993 trans am firebird.

I installed a new windshield on my truck and used this. The stuff is extremely sticky. Use the gloves and don't get in on your skin or you'll try every chemical possible like I did to get it off. Mineral spirits works better than acetone and gas. If it gets on your shirt, you just lost your favorite shirt. It stayed tacky for a while. I put it on the frame and it was 1.5h later before I could get someone to help me lift the windshield on the truck. It was around 85° outside. It rained the next few days and never had a leak so I'm sold on using it again.

Bonds strong. It appears to be a good product

Excellent adhesive, easy to apply and fast-curing. Perfect for windshields with strong bonding and long-lasting seal. Highly recommended product.

Had a leak in my windshield at the corner. I ordered this product to see if it would solve the issue. I put this where the leak was and it stopped water almost instantly! Two days later, I went through the car wash and NO leaks! Caution --- use the gloves provided because this stuff is very sticky and very difficult to remove from your skin.

This product works well for what it is. The quality of install is solely on the user.If you don't heat it up prior to using it, you're gonna have a bad time. The product listing recommends it for a reason. Once heated, it comes out like water.Gloves are highly recommended and I can't emphasize this enough. Don't be like me and have to spend forever removing it from your hands (if you do, use hand cleaner cream and soap+water).I've purchased this multiple times, and it has held in a back windshield, front windshield, and sealed up body cracks that were leaking moisture.It is extremely messy, so use a tool or gloved finger to manipulate it after application! It comes off easily with a little isopropyl alcohol.

Soaked in hot water, wrapped in a heating pad for over an hour. The first few minutes it went easy. The tube cools pretty quickly, about half way through I couldn't squeeze any out with two hands. Many people stated that an electrical driven gun would have been better. If I ever attempt it again, it needs to be hot going into the gun, and has to be squeezed out within 5 minutes.As everyone said, its messy. By the time its over, its everywhere.

My rear window needed to be resealed in my 2000 Corvette convertible and this product help me fix my issue