🚀 Elevate Your FPV Experience!
The Matek Systems PDB Power Distribution Board is engineered for FPV racing drones, supporting 3-6S LiPo packs and featuring a robust built-in current sensor. With dual BEC outputs and advanced protection, this PDB ensures reliable performance and compatibility with various flight controllers, making it a must-have for serious drone enthusiasts.
M**K
Functional layout of wiring, neat and clean.
So far the board has been great for my new 250s pro quad build. This my first full build and wiring configuration. I have been doind more research and doc reading to get familiar with the layout. Im done with the main power connection, no ready to wire the esc’s and fpv transmitter / camera. I will send photos when complete. Thanks for the help.
W**R
Works as expected
Standard PDB with 5V BEC, 10V BEC, and current sensor.I took off one star because if you use this as a PDB for an FC without the same ribbon cable, then you need to solder wires on to the signal pads, which are located in an awkward part of the board.
I**K
Good board, but be careful when soldering.
Very nice small functional board. I think the LED's give it a good look. Only note is that some of the pads can be tricky to solder, ESPECIALLY if you don't put flux on them.Another amazing thing is the ability to solder header pins on the little side power strips (5v, G, 10v, etc) for easy connections with cables.
L**A
Good as always
It’s Matek, no need to say anything. No issues at all several months already and I don’t expect any. Crashing every time and still everything fine. No boise issues no burning issues. Buy it if you need a system with PDB.
D**D
swapped with good escs and motors and still wont work
Out of the box the PDB is giving me different voltages to the ESCs, two of the motors wont work. swapped with good escs and motors and still wont work. :(
S**N
Easy to build on, Great paired with the Matek F405.
One of the easiest power distribution boards to build on. Works great with the Matek F405 Flight Controller. I used one of these on the 225mm Quad that I built and it works flawlessly. And, my wife liked it too, so much so, that when her flight controller went out, she had me replace her whole stack with the F405 and this HUB. I have had multiple flights with this PDB and so far no issues. I will update if it does fail. Have had two hard crashes and its still going strong.
K**D
Good PDB for matek boards
Solid PDB, does what it should and easy to solder. Unfortunately I crashed it pretty hard with no capacitor and blew the regulator.
B**E
You get what you pay for
Went through three of these board, all burn put on the power rail. Maybe I just have horrible luck
Trustpilot
1 week ago
3 days ago