MG Chemicals8341 No Clean Flux Paste, 10 ml Pneumatic Dispenser (Complete with Plunger & Dispensing Tip)

The MG Chemicals 8341 No Clean Flux Paste is outstanding. It delivers excellent wettability, making soldering tasks smoother and more efficient. The syringe applicator allows for precise application, even in tight spots. Its non-conductive, non-tacky residue requires no cleaning, saving time and effort. Highly recommended for both professionals and hobbyists.

Used for some retro console mods and repairs and mech keyboards mods and upgrades.Please note if it is not stored properly it WILL go thick be very hard to push out of the syringe.If it does go thick you can use it like regular solder use a fine toothpick to place it.If you want to revitalise it you need to squeeze it out on to a small tub and mix it with solder flux and it’s good to go

If you're in need of flux for your soldering projects, this one might be what you're looking for. It works very well at cleaning metals, ensuring solid solder connections, particularly with delicate SMD tasks. For instance, I tried it out when soldering some ICs with fine pitches and it did the job admirably.But, the consistency is quite thick, which can make it tricky to apply, and the syringe isn't very sturdy - often leaving a residue afterwards. Cleaning off this residue from the PCB and tools can be a bit of a hassle. Additionally, although it performs effectively, the price might seem a bit high for its value. Make sure to ventilate while using it as it releases fumes. If you can handle these challenges, adding this flux to your toolkit could be worthwhile!

MG Chemicals 8341 No Clean Flux Paste,Good flux, you get a good amount which will last in my case.The flux melted quickly and effortlessly. I would say with this stuff the consistence is good you have to push extremely hard in order to get the stuff out.This as most flux does leave behind a vapor so if new best make sure you use this in a well ventilated room.Overall its good quality flux, says no clean buts it always wise to clean up after using as it take a mere for mins.

Initially I noticed this flux was very difficult to push through the syringe applicator. The plunger is an awkward, loose fit into the main body and it took way too much force to squeeze out the needle.Once applied to the solder joint it didn’t seem to want to adhere to the board and preferred to stick to the needle and pull away.After reading some reviews that mention warming before use I thought i’d give that a go. I found the flux to perform much better. It becomes more towards a softer paste/gel and is much easier to squeeze out of the tube. I also liked how the flux behaved. If you work in a colder environment (hangar/workshop/garage etc) in a colder climate then i’d suggest this might not work for you, unless you’re prepared to preheat the flux first.

Used with desolder braid to remove surface mount it's. Great flux . No problems

Great product will buy again

Really flows well without burning. Not much fumes compared to other, cheaper brands. Definitely would recommend it.