Classic Accessories StormPro Heavy-Duty Boat Cover, Fits Boats 12 ft - 14 ft Long x 68 in Wide

This is a great cover for the $80+ price tag. I trailered this cover at speeds up to 80mph with no problems for roughly 1500 miles and through 2 major rainstorms. The cover is not waterproof but water resistant. I was bringing back a kitchen table in the boat and when we hit the first rainstorm. I pulled into a gas station to check on the table and found it just to be slightly wet but not soaked. I was worried the table was going to be ruined. When we got home it was still lightly raining so I uncovered the boat to remove the table and found that the only thing that was slightly wet was the table. The chairs and everything else were completely dry which was a plus. I used sponges and small towels under the cover on corners and on the motor that I thought might be points that might wear fast or possibly tear. I was also surprised that the cover even covered the boat's motor. I did not use the included center support pole while trailering as I didn't see a need for it and wasn't sure if it was supposed to be used while trailering. This cover held up amazingly well and fits my 15ft StarCraft perfectly. I am pleasantly surprised that I could find such an excellent cover at an affordable cost. Pictures were taken after about 600 miles into the return trip.

I took a chance on this cover as being cheaper than buying sunbrella fabric and making our own. For the price this seems to be a good value with pretty thick material and nice tie down straps to the trailer. Happy to see it fits the 14’ boat well all the way around, and it could probably work for most vessels of similar size. The beam on our boat is about 54”. The photons down show the center riser in place, which I have not tried yet, but it may be a useful piece to keep water from settling on it.Not sure we will tow with it on- if we do try it, all the strap ends will need to be well secured.

Works great, keeps the rain off and pulled it 24 hours round trip without issues

I need a cover to keep the rain out of the boat as well as to protect it when I'm traveling longer distances (towing). The cover installs very easily and is lashed to the trailer. Because it's a fishing boat cover if the seats are taken out and laid in the boat the cover is completely flat except where the post is placed to give a slight raise. To be flexible with different size boats the post comes with multiple segments. After a while the segments don't stick together as well as I'd like so I put it together at the height that I need and wrapped a little bit of duct tape around the posts. Worked perfectly. I also found if you crank the front of the trailer up slightly water tends to run off the back. The cover fit very well except at the back of the boat. The way my motor is attached to the transom made it impossible to get it to fit flush in the back. Either way there are two straps in the back to let you to synch it down and it takes care of that.Again I want to stress the only reason it doesn't fit perfectly is because I have an old motor that is clamped onto the transom.

This cover is made of excellent quality material, and installed fairly easily just a lot of walking around fiddling with the straps (as would be the case with any cover). I have a basic 14' Lowe V-bottom fishing boat (no windshield or steering console, similar to what's shown in the product listing picture in this ad). Unless you are storing the boat under a roof, or you live where there's no rain or snow, this cover needs a LOT more support in the middle than what the single prop pole (included) can provide. I even bought two more prop poles, had one on each boat seat bench, down the middle. Tightened all the straps as tight as I could to keep the cover tight; and it still pooled water out near the edges of the boat. I will have to make some "bows" out of PVC pipe or similar material to support it even better. Great cover, but the prop poles don't cut it in Wisconsin weather.

Putting this cover on when it first arrived, my wife exclaimed, "this clip isn't like the rest" ... Shure enough it was broken and the other part of the broken clip fell out of the elastic hem.This cover fits the boat well. Water runs off for the most part. The middle support pole keeps the middle part up and my foldable seats keep the cover higher down the center line. I wish the vents in the back were faced 90 degrees so that they didn't act like funnels.

The cover fit great and the fabric is very strong with plenty of tie downs.

Could not find a boat cover in the brick and mortar stores. I even searched at the boat show. No one carries boat covers. After searching online I came across this one. It's exactly what I was looking for. I have a 12FT boat so of course it fits perfectly. The quality can't be beat. Better quality than my old cover. There are other less expensive covers out there but remember you get what you pay for. The price of this cover is worth it!