12mm Pre-wired Led Momentary Switch

They work

Don't like the large shiny push buttons in your black case? Like a soft blue glow to indicate when it's on? HERE's YOUR BUTTON! Used with a Geekworm X735-v3.0 Power Management board being supplied 24V to control a Pi4 8GB with a 7" screen.

Used as a defeat switch for very loud VESS system in a Niro EV. Light on when you start car, push button light and VESS off, push button again light on VESS back on. Works perfect, and very easy to install.

(Purchased 2)I mounted these in my motorcycle frame so I could wire up my garage and gate remotes. Worked perfectly.

The color is not even close to yellow, very orange which is what I wanted anyways but they don't advertise that color.

👍🏻

The media could not be loaded.  So I needed power buttons for my PC build, but the rub was that they had to live 6ft away from the actual motherboard. So I cut the pin connections off an old pc case, married them to some long multi colored jumper wires I had laying around and then attached them to these 12mm APIELE buttons. Two wires for pc switch, two wires for PC power light, two for reset switch and two for HDD activity light. Plugged them in and it worked like a charm.I was going to do Green LED for power and Yellow for HDD activity but the yellow led APIELE button was disappointingly dim compared to the green. So I just used green for both. I'll label them later.Then I just drilled some holes in a couple keystone blanks and screwed them in. Viola.... long PC power buttons with a clean keystone plate finish. Now the wires can live in the wall and go to the pc and all you see are neat little buttons and lights.

The switch works great but the LED ring is not very bright. I would prefer that is was much brighter.