Rocaris 72 Pack Wire Wheel Brushes Set, Brass and Steel Wire Brush Set 1/8" Shank for Rotary Tools Accessories Polish Clean Tools

Thought they were good quantity for the price, plan to reorder when needed.

As far as these go you get a lot of the money, & true to the advertisment the shanks are heavy duty, but the wire collar isn't. In my set the shanks of all the brushes except the vertical steel ones were extra long & could not fit into either my Dremel or my AllTrade case with the lid closed.The vertical style brushes outperformed in every way I could have wanted! However the cone & horizontal brushes will yeet wire into you, & everything else in the vicinity at only 10,000 rpm (lowest setting on my Dremel- the highest setting is around 30-50K) I recommend melting some flux & solder into the core of them if you know your going to need it @ higher speeds, or length of time. You can also use Elmer's Wood Glue as a weaker substitute, but that may rust the steel brushes over time. Either way after all the wires are gone I'll be able to cut up the collar & shanks into some other useful tool bits.

Safety glasses are a must! They come apart pretty easily but do a great job and for the price they are disposable. Cleaning my Ktm throttle body and they were perfect for all the tight areas

I was able to use this product recently and found that wires come off the shaft easily. Please make sure you are using Safety Glasses when using this product to prevent any injury to your eyes.

I was brushing dirt and grit off gem stones. The bristles flew off all over my hair, my clothes and everything else within 3 to 4 feet.If you do buy these WEAR SAFETY GOGGLES!!!!!!!!

Good Tools just don’t go above number five on the Dremel speed .

These bits are similar quality to that of name brand dremel bits. I've never used a single wire wheel bit that didn't come apart during use. Yes the wires will fly, what bits have you used that don't lose wires? The harder you press, the more wires break. You only need to barely touch the item to be effective. The more pressure you use, the more they fall apart. And trust me you can make one wheel last 20 minutes or more if you use it properly. Sounds like most of these reviews are using a dremel for one of their first times.

They are pretty good, the wires are thin so they don't hold up really well,I'm currently using them to remove rust on steel deck chairs.Averaging 3 a chair. But with the amount you get for the money, it's worth it.And they last I as long as name brand brushes. I recommend putting something down to collect the brush pieces, or sweeping really well after the project. I stupidly didn't wear shoes the first time I used them and got a few wires in my feet, it's not pleasant. Don't be dumb like me.Ok, kisses

As expected at this price point, these wire wheels and brushes disintegrate quite a bit faster than Dremel brand products. The brushes are a bit sturdier than the wire wheels. This set would be good for light work and low rotary tool speeds, but anything heavy, like rust removal on metal, is probably not the best idea. It's not just that they don't last; no wire wheels this size last very long. But when these wire wheels disintegrate, they REALLY disintegrate, suddenly and thoroughly, embedding wires everywhere. Don't even think about forgetting eye protection when using these. Wearing a mask and toque is also probably a good idea with the wire wheels in case you turn your rotary tool speed a little too high, or use the wheel for too long and suffer a sudden face full of wires.

Livraison très rapide, en bon état et semble de bonne qualité

Used one steel and one brass versions of these wire brushes in my rotary tool and they basically exploded in a rain of wires. I had wires stuck in my arms, my shirt, my face. Maybe a slow speed tool would be ok but on the lowest setting in my tool their were dangerous.

a manipuler avec précaution très fragile!!!