🛠️ Upgrade Your Cooling Game!
The inRobert DIY Two Ball Bearing Video Card Cooling Fan is engineered for the Zotac GTX 1060 Mini, featuring a 4-pin power connector and a design that prioritizes longevity and quiet operation. Perfect for DIY enthusiasts looking to enhance their GPU's performance without the noise.
| Product Dimensions | 3.35"L x 0.59"W x 3.35"H |
| Brand | inRobert |
| Power Connector Type | 4-Pin |
| Voltage | 12 Volts |
| Wattage | 3 watts |
| Cooling Method | Air |
| Compatible Devices | Gaming Console |
| Noise Level | 48 dB |
| Maximum Rotational Speed | 3800 RPM |
| UPC | 705701299523 |
| Manufacturer | inRobert |
| Item model number | T129215SU |
| Item Weight | 0.32 ounces |
| Item Dimensions LxWxH | 3.35 x 3.35 x 0.59 inches |
| ASIN | B07FP9S1JK |
| Is Discontinued By Manufacturer | No |
| Date First Available | July 19, 2018 |
C**N
Bien para Zotac 1060
Funciono muy bien para mi GPU. Tuve que hacer una pequeña modificación, mínima. Para que el cable pasara bien. Pero de lo demás Perfecto. Muy silencioso y no se balancea ni nada
A**V
Good fit for similar cards
Fits perfectly my single-fan AMD Radeon RX 580 FH.
B**N
Passt perfekt, für meine GTX970 von HP
Habe mir den Lüfter zwangsläufig bestellen müssen, da der alte bei meiner GTX970 einen Lagerschaden hatte. Die Produktbeschreibung ist mit den dazu geschriebenen Abmessungen sehr gut und genau, nach 5x nachmessen am alten Kühler hab ich dann den hier bestellt.Amazon-Typisch schnell geliefert worden, hab ihn direkt eingebaut und hab seit dem wider eine leise -und kühle Grafikkarte.Anmerkung: ich hab eine GTX970 mit HP Referenz Design, d.h. Das der Lüfter nicht zwangsläufig auf jede 970er passt, also vorher Lüfter ausbauen und nachmessen!
D**E
Not a direct swap for my ASUS GTX580 fans, slightly smaller but cooling seems adequate and quieter.
After searching through many fans these were closest to what I needed to replace my noisy cooling fans on my ASUS GTX580 graphics card. (An old card but still useful performance for a backup gaming PC).These fans are about 5mm smaller diameter but had the correct 3 leg mounting with 40mm diag spacing for screws (NB! need to use the old screws). Also the 4 pin plugs are of the correct gender for this card. NB! Use a well fitting small cross head screwdriver to remove the fan cover screws (3 screws are hidden under orange flashes on the body of the cover) Route the fan cables carefully to prevent fouling with the fans.Reinstalled and tested using 3D Mark software and adjusted cooling curve to maintain good cooling with lowest possible fan speed. Nice and quiet. BTW not too noisy when set at 100% speed. Cant comment on reliability as early days. Very pleased I can still get service from this GFX.
L**Y
Bon un ventilo quoi.
Pas de probleme,
Trustpilot
2 weeks ago
1 week ago
