SHDIATOOL Diamond Cutting Disc 250mm / 10 Inch X Mesh Turbo Saw Blade for Tile Marble Ceramic Porcelain

Bought for a new bridge saw that came with two un branded blades. Unfortunately these blades were trying to polish their way through the limestone I was trying to cut.This is not the case with this blade. Easily cuts through 20mm limestone leaving a nice clean cut. Probably up to 20 meters cut so far and still cutting well.

Needed it for today got it yesterday, perfect, great product

Ordered two of these for use with wet table saw cutter. Needed to knock out the two steel inserts (sharp tap with hammer) to get to the correct diameter for my cutter spindle. Blade made a reasonable job, although you could see very fine splinters on the top cut surface of the tile - I'm going to say that this might be attributable to the salt-tec 800 x 400 tiles themselves as they seemed slightly prone to chipping during installation. Only made half a dozen cuts and blade was still in great condition.

I am an experienced tiler and have been using various blades for years on my grinder. When I came across these Shdiatool blades I thought - for that price, I can't really lose it's got to be worth a try. I was amazed at the quality for the price; these cut clean through standard floor tiles unlike other similar priced alternatives from toolstation or screwfix - these are great. They maybe last around 20-25m cutting but at this price you can afford to buy 3 or 4 and when they begin to be blunt just bin them and fit another one. To think that I used to pay 4x as much for pretty much the same quality from Tilepal - effectively I am earning more money through discovering Shdiatool discs. Having enjoyed these so much, I've actually bought a few of their angle grinder hole cutter bits too and they're equally good. Very good brand; highly recommend them.

Best blade's for cutting tiles. Very smooth no chipping .Very happy 👍.

excellent quality, better than the original, slight wider cut, bt cuts straighter

This one is a very good product but sadly it didn't fit my Maketa!

I have a DeWalt D24000 wet tile saw. I have bought 2 Dewalt diamond saw blades and found that after about half a dozen cuts in porcelain tiles they would struggle to cut and the blade would need constant redressing. This was really frustrating. Bought two of these as they are half the price of the Dewalt, and guess what? They cut really well. I have no down time as they give a constant cut every time and the cuts are really good little to no chips. Will certainly buy more of these as and when I need too. Also they last a long time. Cut over 60m2 of hard porcelain tiles and there is still plenty of meat on the blade. I hope you find this usefull.