BusBoard Prototype Systems SA180 Adhesive Standoffs, 24 Pack, 0.180" Height, Offset 0.6x0.6 Base, Fits 0.125" PCB Hole

As the title says, these offsets are sturdy and fit in PCB holes fine. The boards don't move on them once placed, and can be removed by pinching the head of the offset. However, the backing adhesive is hit or miss. I've placed these on wood, and laminated plastic, and they hold, but not too well. I'll occasionally have to replace them every few months. If you're using in a lie flat application, these should do well for you.

Nice standoffs, glue works well, definitely doesn't feel like it's going to pop off.I would buy again if needed.

I’m very happy with these standoffs. I used mine to mount a relay board and a raspberry pi to the inner steel walls of the control box of my air conditioner for a project I did to automate the controls. I’m very impressed with how strong the clips are and even more impressed by the adhesive used to mount them. Even in this air conditioner where there’s a lot of vibration these little standoffs are staying stuck down rock solid. I’m very happy with these and would highly recommend them to anyone that needs them for a reliable solution!(Also a side not to others wanting to use these with raspberry pi’s: I had to widen the pi’s mounting holes just a little bit to get these mount pins to fit through them. They just a touch too big to fit through without a small mod)

I needed these prime in a pinch. They worked fine but I expected to be able to get a bag of 100 for the price I paid. The offset design is nice. I tried to find centered ones but it turned out that for my use the offset design was actually better anyway. Adhesive is touted as 3M but I didn't see any markings, just the green scotch looking design so I have to take their word for it.

These will fit the arduino board, but will not fit the smaller board used with Arduino without modifying them.The adhesive holds very well, plastic seems to be of good quality. Will buy more when needed.

I purchased these - SA180 Adhesive Standoffs, 24 Pack, 0.180" Height, Offset 0.6x0.8" Base, Fits 0.125" PCB Hole for $8.00 for a special project and will have many left over for use later, but for 24, that is $0.333 per standoff and that is quite expensive, as you will usually use 4, with one on each corner, growing the cost of the project with two PC boards by $2.66 for the standoffs. The 3M sticky foam is good, but if they don't stay stuck, it will make it inconvenient to keep adding the sticky foam to hold them on the box and I did not want to drill for each board. ! I like them well enough for three stars.

These didn't work for my application but they seem like they would for someone who does a better job measuring than me. The standoffs were too wide for my holes and the feet were too wide for my case. If you're working in a tight box, these might not be the best fit for you.

These were a little too low for a standard motherboard, but they did work. No complaints here other than the back of the sticky tape was a little difficult to remove