20W R7S J118 LED Light Bulbs 120V R7S Base T3 Double Ended 200W Tungsten Halogen Bulb Replacement Bulbs for Workshop Lighting Floor Lamps (Daylight 6000K, 2-Pack)

So I bought these bulbs to replace the ones that burned out. They are definitely a little brighter and fit perfectly in the work lights but don't produce any of the heat of the others. Lights up an entire room well so you can see everything you need to, however they cannot be dimmed at all. If you set them to a dim setting on the work lights they flicker really bad. Almost a strobe effect. Overall they are great for their price and I would definitely recommend if you aren't working in the arctic

Followed the instructions and breezed right through. Had to change the on/off switch but it was ok. Nice bright light with this lamp.

I bought these LED replacement bulbs to get rid of the super high wattage halogen bulbs that get hot enough to heat a small building. Replacement was easy. Unfortunately the wattage of these bulbs is only 20 so they’re not as bright as I need them to be. They are installed in a telescopic light stand that I use in my shop for close up lighting. They actually work ok but need to be about twice as bright for my application. I wish there was a 100 watt replacement for these halogen bulbs but haven’t seen one. So if ya don’t require really bright light - they work. For that lower light output, I gave them a 4 rating.

Works great, easy install, no heat issues, not as bright but does the job very well!!

Didn't fit into work light, no matter what I tried to do. Had to return. Intended to replace halogen lamps.

These bulbs work great!

I have a dual bulb HUSKY halogen work light. My findings:PROS-not as bright as halogen but still pretty decent and acceptable. Can’t comment on longevity yet, I just installed and deinstalled it(see below).CONS-had to remove 2 screws that held the reflector in because the bulb diameter is a tad (1/8”) too large and the bulb bridged on the screws. Can’t install 2 bulbs next to each other in the reflector housing (sans screws) next to each other because the bulb diameter is too large.Not sure what to do at this point. I bulb is bright and I love the sharp 5000k light. It’s a blessing for those of us with aging eyes. Not being able to mount 2 next to each other in the housing is a showstopper.

Bought these to replace dead halogens in my Ryobi work lights. Fit, good light. No heat, which I wanted when I ordered them, but could use now! Good value. Don't know, yet, about longevity, but LEDs are supposed to be long lasting and the halogens had a short life.

I like because bright white but a little bit bigger and didn’t fit with other model of work lights

Works as advertised, needed to modify install in fixture, however I was aware prior to purchasing

Ordered 2 of these. Both don't work

Minor adjustment to reflector material to fit .

It's used in a garage light ...very useful