Fusion Chemical Machining and Grinding Fluid | Cool 2240 | General Purpose Coolant for Cutting and Grinding Machine Shop Operations | Semisynthetic (1 Gallon)

Works great

I bought this for my Wellsaw band saw in my shop. It gets infrequent usage, and some oils degrade over time. Thus far, this is working great (just used it today) with no obvious breakdown or spoilage. Priced very fair too, especially considering the dilution rate.

I simply overlooked reading the label, I was going to use it for lapidary, but after some irritation started I read the label, drained it and put it away for use in the application it was meant for

It’s been about one month since I flushed and refilled my vertical machining center with Fusion cool 2240 @ 7.5% concentration. Compared to the prior coolant I’m getting much better finishes on stainless and aluminum, easier drilling, and no rust on my vise after sitting a few days. There is no offensive odor and it leaves a protective residue on everything but it’s easy to clean off. It’s even lubricated my vise so it works like new again! As for sump life the jury is still out.

Works great for what I needed on my machine