for ELEGOO Saturn 3/Saturn 3 Ultra/Saturn 4/ Saturn 4 Ultra Screen Replacement,10.1 Inches 12K Monochrome Original 3D Printer Screen with 11520x5120 Resolution

Fits perfectly & works great... now let me share a few secrets that will make installing a LOT easier and faster!1) You don't need to disassemble the unit into a million parts as their video shows! They do it because they want you to separate all of the wiring, but unless wiring is your problem, just leave it connected! Just take off the front plate.2) No need to replace the LCD cable - just disconnect from the original LCD connector built in to the monitor. We are just going to connect the LCD connector to the existing cable!3) The old lcd is hard as hell to lift out due to the super-strong glue/tape used by the factory. Even after heating, I couldn't get it out.. So I used a screwdriver to pry it out, which cracked to old LCD... but you don't need it anyway! Toss it! Save your time, just pop it off, remove the old glue, clean support edges up with alcohol, install the new double-sided tape supplied, and reconnect the new LCD. Use the included black protective tape to seal the LCD seam.4) Screw the font plate back in place and you are ready to go. Total time about 15-20 minutes... your mileage may vary! If you are unsure just follow the video they made (quite good) and do it their way.!

I’ve bought twice to replace the LCD screen for my Saturn 3. Both times worked like a charm, no complaints.Shipping could be quicker

I searched the boxes well (I got two) and there is no double sided tape the holds the screen down.othwrwise it's fine. It's well packed with foam to prevent breakage. Replacement cables are in thr box if you need them.

Good support. Quickly replaced a defective screen. Easy to install. Possibly ship in a better box so carrier doesnt damage it as easily.

The screen works as intended. I started getting the black spots and knew I had to replace it. However the replacement process isn't as simple as previous Elegoo models. You do have to basically take the entire printer apart. They also have globs of glue on every connector which on my part ended with a ripped wire on one of them after removing the glue. Do not follow the directions for the wire disconnects and only disconnect the wires needed to separate the bottom and top. Spliced the wire together but I get a warning on the x axis and the stop sensor at the top stopped working while troubleshooting the torn wire. Very poor replacement process for a perishable part. Also support has not reached back out to me after 3 submitted request for assistance even though there after sales team have been excellent in the past.

This screen is exactly what you need if your Saturn 3 Ultra lcd stop working. The instruction video is a simple, step by step process.

IItem is completely as described easy to assembled with Youtube as a guide.. working great

showing photo of old screen, with the new one installed, part of the screen will not light up. EDIT: after my review, the seller contacted me and sent a replacement free of charge. New screen works great