3M Door Edge Protector (2 Doors) PRE-Cut Guard Scratch 3M Protection Film Clear Invisible Universal Car Truck (2 Door)

I used this film on my 2013 car, and it held up fine for a dozen years. I got a new car with bigger doors, so I was evcn more concerned with the door edges hitting things, so I quickly ordered and installed the protective tape for the new one. Like before, it installed easily and is nearly invisible once applied.

This door edge protector is very good. I am using the clear one on a medium-dark blue car. It is minimalist and is not visible until you are close to it. Perfect. It gives good bump protection. Installation was different than what I have used in the past (those were a U shaped strip that fitted over the edge of the door). This one is a flat tape that you apply to the outside all the way down the door and then carefully fold over the edge of the door. Installation was easy and it comes with good instructions. The tape is very flexible and stretchable and easily fits to the curves of a door edge with out wrinkling or kinking.Since this is tape that sticks to the door, I am hopeful that it will not get dirty under it as time goes on. (That is a problem I always had with the U shaped type).A little pricey, but IMO, worth it.

Bought these in hope to add protection to the ever so fragile paint on the doors and back hatch of my 4Runner. I like that it is an easy project anyone with a steady hand can complete in minutes. I like that it is low profile and almost invisible. Hopefully it will prove to be durable to hot summers and car washes, and most importantly accidental door dings that chip away at the paint!

I read a review here that suggested to spend the extra dollar to get the 5 door package if you’re doing 4 doors so you would have a spare if you mess one up. So I did. Didn’t mess one up, but two of my doors needed longer than the 5 30” strips I received. So I needed the extra strip to splice onto those two doors to cover all of the outside edge.I followed instructions and the product went on well. I wore nitrile gloves to help prevent compromising the adhesive. Good elasticity to allow it to follow sharp curves smoothly.If you do have to splice, don’t press the end of the first strip down all the way until you start the second one. The strip blends so well that I couldn’t find the end of the first one to know exactly where to start the second one.Job turned out as well as my other car that was done by the dealer.If you need more than 30” per door, buy extra.

Great product, delivered within a day, easy to install. Just have to take your time installing but when its on you cant even tell you have door guards on. Keeps a clean line look on you vehicle.

I ordered the 5 door option for a Tesla Model 3 and there looks to be plenty of material for me. I successfully installed on the first door. I erroneously didn't fold over the sticky tape termination to make it easier for the 2nd door and boy was that trouble! I spent over an hour trying to remove the backing and gave up yesterday. I finally went to the other end of the roll and manage to separate the backing. I then did the fold over tag trick to finish the other 3 doors of my car. I will do the trunk tomorrow.I found the product easy to use once I got the backing off. I didn't have any problems with bubbles and time will prove regarding the longevity but I'll be happy if it lasts 5 or more years.This tape is super thin and the backing should really be a little wider that the tape to make it easier to separate.

Very thin 3M material and also not as wide as what a dealer would put on your car (this is thinner and narrower). Nearly impossible to line this up and get it to stick in a consistent and uniform way down the door. Gave up after 2nd door attempt. Most doors have angles, this just folds over itself, bubbles, looks awful. Will just pay the dealer $100 to have this done. Inferior product, ineffective. Do not recommend.

Theese door protectors fit perfectly and were easy to apply to my car. Instructions to apply them easily was included.