BALL JOINT KIT - COMPATIBLE WITH JEEP JK WRANGLER OR WJ GRAND CHEROKEE DANA 30

Install went well. Seem very durable. We offroad 4 or 5x a year. I'm sure these will hold up. Tightened up the front end a bit too after 130k miles, nice to refresh these

The factory ball joints lasted 100,000 miles so this is what they were replaced with. Cry once. I suggest doing your inner axle seals, front axle U-joints, both Hub assemblies, I used Timkens and the front brakes if you need them. You will have to remove the axles, brakes and hubs to do the ball joints. I set aside an entire weekend in the garage. Clean all the rust and use some parts cleaner before replacing the ball joints. If you’re in the rust belt it’s imperative that you smack the knuckle/axle under load of the press with a sledge or the ball joints won’t move. Don’t worry it won’t hurt it. These are sealed so make sure they’re full of grease. One didn’t have any so pay attention and grease it if it’s not. If it’s greased, send it. I am a mechanic but this isn’t an extremely difficult process. It’s pretty straightforward.

I returned this item do to came with not original box and one so far was ready loose I didn’t trusted to put them on my jeep but comunicación was fast and also refund.

Just had them installed and it rides great! I figured a name brand and costing way more than the cheap ones, I should do ok.Added a 3/4" spring level and no Death Wobble!