Highland (1125100) Ramparts 12" Professional Series Aluminum Ramp Top Kit - 2 Piece

These are very strong. I use them to load a zero turn in and out of a shed with a plywood floor. They stay put and do what you expect. I would definitely go with the 12" over the 10". That little extra width sure does compensate for variations in steering.

The top ramp ends seem strong enough. I would suggest that where the board fits into the ramp end, that it be made to fit tighter---it's significantly more than 1 1/2 inches so there is a lot of slop until the bolts draw it up tight. Also, the self adhesive rubber pad is too small to cover the total area on the end to protect the surface that the ramp ends are put on.

Works just fine. They also provided temporary pins so it stays in place.

Work great with wide board. My boards were 'rough cut' so ends had to be planed down to fit.

These are excellent quality. Had mounted on my 2x12 treated boards in less than thirty minutes and loaded my JD GatorOnto my trailer with no problem.

These are excellent ramp parts. Very Heavy Duty. I think the 10" would have probably been OK for me.

I fastened each ramp to a 2 inch by 12 inch by footer and then drove my 21 horsepower Craftsman riding mower up and down the ramps to my shed several times without a problem. The shed floor was about 1 foot high so you can picture the angle of the ramps.

Heavier than the standard one, just wish it was in a set that included the end portion. I am glad I ordered these instead of the lighter version.