Ancable Replacement 4-Pack TRS Male Plug 3 Pole 1/8" 3.5mm Solder Type DIY Audio Cable Connector for Repair Headphones Headset

These headset connectors are fairly ok to solder if you have done soldering before. It can be a struggle to get all the connections perfect in the small space however any more room and the plug would be too bulky, I think they have got the balance just right with this one.I actually bought these to use with headsets but have actually used them to update a pair of 70's stereo headphones (bridged out the mic connector) and it worked great!.

They do a job, I managed to replace a plug that had failed on some very old headphones. Once I'd worked out which wires go where (common earth is easy, left and right is trial and error), it was easy to solder. They isolate well enough. They are low-cost items, so as long as your expectations are commensurate they will do what you need; sturdy enough for a headphone jack.

Good value pack of 10 plugs, easy to solder and did the job well for connecting the lights on my power swr meters. 10/10.

Not high quality. Four of my pack were Wonky (see picture). That metal shaft is very slightly shorter than I'd like, so it cannot click into place on my mobile phone with my case on (which Ch adds a mm or two of 'depth needed') Fine without my case. Also fine direct into an Xbox one controller jack. It arrived fast (Prime same day) with heatshrink. Still I'll try to use them. Good Luck to me in soldering my son's tiny headset wires onto this. Something to do in Coronavirus Lockdown, eh?Edit: 5 hours and 6 plufs later, I've failed. Too small to work with; you need yo be an elf. Or a dwarf. Or have the eyes if a hawk and hands if an imp. I was so so close but whenever i completed somethibg contacted sonething else yo bugger it up.I think I should wire to a big old jack ibstead then use a big-to-3.5mm adaptor..!

all fine

I was able to crimp the connections rather than solder which I find easier and a more permanent connection.

works well though it can be difficult not bridge the solder on a couple of connections as they are really close together, otherwise a very good product

perfect for my project

Alles gut. Vielen Dank.

La note générale est de 5/5, bien que je n'ai mis que 4/5 en solidité, car cela me semble un peu fragile.Quoique, ça tient pour le moment !Fait le job, mais à confirmer dans le temps.3/5 pour le style, car cela est fonctionnel, le kit es très complet, mais l'esthétique n'a pas de quoi se rouler par terre, c'est vraiment basique.Toutefois, je recommande tout de même vivement ce produit !

Todo correcto aunque me costó un poco soldarlo porque los contactos son pequeños.

Il jack è perfetto, sinceramente non capisco le valutazioni negative! Dopo un po’ di tempo x ricollegare i fili e controllare i giusti collegamenti richiudo con la sua guaina termo stringente( che è in dotazione nel pacchetto che vi arriva ) avvito la parte esterna e inserisco il jack nel controller della console: si inserisce perfettamente, non ha giochi e soprattutto le cuffie funzionano. P.S: la stagnatura è ottima , in quelli che mi sono arrivati i fili si stagnano benissimo poi se uno non ha dimestichezza con lo stagnatore e riscalda il jack fino a far fondere l’isolamento dei settori non credo si possa dare la colpa al prodotto. Prezzo nella media con quello che viene proposto

4 stekkers mèt krimpkousjes, dus geheel zoals aangeboden. Prima.(Minder is dat de - aldus de verpakking - 'Plug and Play' optie niet werkt ;-) )