Teng MDSCR Engine Gasket Scraper

Used this a fair few times now, does exactly what it's supposed to do! Very sharp tip which goes through old gaskets with ease! Makes my job so much easier!

Removing a head gasket

good gasket scraper! be careful not to chip aluminum surfaces

Great product

A little unsure after reading comments but Just the Job, Teng is the way to Go!

Good enough for Wheeler Dealers. good enough for me. Top bit of kit.

excellent

I'm disappointed by the quality of this. The 'cutting' edge does not even follow a straight line (it's slightly concave, but not in a deliberate looking way), it's not square to the shaft and when you run a finger nail along it you can feel machining groves.This is advertised as an engine gasket scraper so I was expecting something quite special at the cutting edge to minimise the risk of damage to the surface being cleaned; I wouldn't and didn't use it for fear of damaging the mating surface.This is the first tool I've ever bought specifically for scraping gaskets, I can't believe they are all this bad.At £10.00 I'd say it's way over priced, if you picked it up for a quid at a builders merchants to use as a small pry bar then you'd probably be quite happy.Do yourself a favour and look for another product (I have always used Stanley knife blades in the past).I'm going to try and return mine.

More accurate and safer than using razor blade on my engine block. Old gaskets just peeled off. Should last for a long time.