DIY Guitar Kit Telecaster Kit, TL Style Guitar Kit, 6 String DIY Electric Guitar Kit Maple Body/Maple Fingerboard, All Components Included

The guitar body is not as shown in the picture and has several large knots in the wood. The are no through body string holes. The bridge pickup routing is off axis by about five (5) degrees. The wire channels are rough and show signs of being drilled with something other than a pilot-point type bit.. The neck is an in-bowed twelve (12) inch radius with a knot in the headstock. The neck fits loose in the guitar body neck route and needs to be raised about 3 inches at the nut to get the strings above the neck. The hardware and electronics are low quality, ceramic magnet pickups (4.9K & 7.4K ohm) . . . etcetera.

Not doing 1 star because Amazon is known to remove those. Was sent a kit with a pickup that the screw holes didn't even line up with the bridge plate. Also 0 instructions provided. Questions said pre drilled pilot holes in the neck, there was none.

No intstruction , all holes predrilled in wrong place .

None of the pockets are placed and drilled properly.Thru the body holes ARE NOT drilled in the bridge, pilot holes for wiring were not drilled clean.Body requires a lot of sanding for the finish,I’ve never seen a Maple body this light, the neck weighs more.Lesson learned, You do get what you pay for.This will trashed!DO NOT WASTE YOUR MONEY, spend a little more and at least get something to work with, not one to totally redo.

The fitment was all wrong, the bridge pocket was crooked, the through holes were drilled in the wrong place, and the neck would have never fit in the body pocket. Save yourself some frustration and DO NOT ORDER. Amazon should remove this from their site.