SCOSCHE LOC90 Car Stereo Speaker 2-Channel Audio Adjustable Level Lineout Converter

Very good adapter 👍👍👍👍

I got this to add a sub to my car. It connects to the door speaker cables and you have a volume control for the sub that sits under the dash, so you can control the bass level.I didnt want to change my head unit, and because this plugs into my existing wiring, it was the ideal solution.

Es muy fácil instalar y algo que me sorprendió fue el cable del remoto que también apaga el amplificador

Have purchased 3 of these over the last few years for various cars and never had any issues.

Got this installed in my 2008 Toyota Avalon XL after a painstaking process... And it sounds great! I'm using it to power a 750w amp and two 350w subs with my stock head unit. Note, Camrys of this generation have the same wiring colors. Didn't have to adjust the gains for my left or right channels, just tapped into the rear speakers (Left Rear - Yellow with Grey stripes (+) , Black with Grey stripes (-). Right rear - Red with Grey stripes (+), White with Grey stripes (-).I tapped into them on the seat belt column area. I suppose you could do it at the head unit, but I felt safer doing it behind the seatbelt column panel. You can tell they're the speaker wires because they're the only wires intertwined together. The rest of the wires on the harness are not. I used wire taps where you crimp two wires next to each other together with a piece of metal, so I didn't have to cut wires.To get the 12v constant, I simply crimped the wire to a 5A fused line, then crimped it to an extra wire, which I stuck into the "B+" input on my amp, joining it with the power line from the battery.For the ground I did the same thing, routed the wire to the GND input on my amp with the ground wire stuffed in there.The Remote wire actually works very well and for now, has not given me issues. I was relived to not have to route another remote wire from some electrical part of the car, and I could just crimp a wire onto the remote wire from the LOC and connect it to my amp. It only turns the amp on when the radio is on. Perfect.My only fear is if the LOC Remote wire circuit malfunctions for some reason and causes my amp to kill my battery or something. Maybe there's a protection built in for that.Didn't seem to work at first and I thought it might be defective, but I re-did a few connections and it worked! I noticed more bass immediately and knew it wasn't my interior speakers.I connected the bass control knob, which I routed through the interior panels and it works flawlessly! It has a very wide range and is quite sensitive, at least for my set up. Turning it all the way down will essentially turn your sub off, so that's nice for when you need to go incognito!Couldn't be any happier with this. I didn't want to mess around with an aftermarket headunit so I decided to save myself a lot of headache and money. This will do the trick as long as you can tap into the right and left positive and negatives. Of your speakers.

It just does what you need it to do. I used to install a sub+Amp and this took the high signal from the factory sub, and gave me signal, remote, and further adjustment! I've got my new dubs dialed in perfect thanks to this. and the remote is a great touch. Makes it feel much more premium.

Awesome line output converter! I hooked it up to the wires connecting to my factory bose amp. The setup gives a perfect signal to my aftermarket amp. Control nob works good too