Stormguard brandTrusted for durability and efficacy (fit-for-purpose) - by a family run company based near Manchester with over 150 years experience in the rain and draught excluder industry.Fitting Instructions1. Measure the door for required length of draught excluder.2. Slide the brush strip out of the PVC carrier.3. Cut brush strip to size with a hacksaw.4. Cut PVC carrier to size with a hacksaw.5. Feed brush strip back into carrier and pinch either end with a pliers to prevent movement of the strip in the carrier.6. Position the draught excluder against the door so the brush strip closes the draught gap.7. Mark screw positions with a pencil through slotted holes for fitting screws.8. Drill holes with pilot bit thickness less than screw thickness - screws will then fit easily and without damaging screw heads.9. Fix draught excluder to door with screws and adjust up or down as required by loosening and retightening screws in slotted holes.TipIf a join is required, create a seamless join between the two pieces as follows:1. Cut the carrier into two equal lengths so both together cover the entire garage door width.2. Cut one length of brush strip longer than it's carrier on one side.3. Cut one length of brush strip shorter than it's carrier by the same amount.4. When fitting, feed the brush strip protruding from one carrier into the other carrier so it keeps the two carriers alligned.
A**R
Not to be cut to size under any circumstances.
Don't cut it, it's all joined together by a satanic thread. Once you've done that you may as well chuck it away.
Trustpilot
2 weeks ago
1 day ago
