METOWARE Trailer Hitch Pin, 5/8" Dia Anti Rattle Pin Fits 2" and 2-1/2" Receiver Tubes, With Extra Safety Clip for Hollow Shank Cargo Carrier, Bike Rack, Hitch Step (1 Pack)

The shoulder on the bolt is too long for some hitch receivers... you run out of threads before the nut is tight against the inside of the hitch receiver. If you tighten it down, and the hitch still wobbles, you need a washer. The manufacturer should supply this, but they don't, so deducting a star.

I have a step that attaches to my hitch. I didn’t want anyone to simply pull the standard hitch pin off and steal it within 60 seconds. Cheap locking pins can be broken off with a long pipe. So I bought this and installed two additional nuts and lock washers on it. I also installed a bracket that holds the step tight onto the frame. They will have to use a deep socket wrench to remove the nuts individually. Along with different size sockets to remove the bracket. It is still possible to steal but it’s going to take time to figure it out and remove. The longer it takes, the more likely they will move on. The pin is solid.

Excelente producto

Easy to install, Draws the hitch to the receiver real tight, stops rattle noise

Easy to install, works great

What a waste of time and moneyMy hitch still rattles , I had a similar one on my other truck it was cheaply made but it worked good, this is just like a regular pin but much more expensive 0 stars

I bought this thinking it would hold the hitch in solid, it did not. It wobbled as much as without. Possibly installed wrong though probably not, it wasn't difficult to understand