JK Turn Signal Lights Assembly Compatible with Jeep 2007-2018 Wrangler JK & Wrangler Unlimited, LED Front Indicator Blinker Amber with Smoke Lens (1 Pair)

Easy install, works as expected.

Good fit. Works as it should

The driver side did not work so luckily I really only needed passenger side

My first impression on unboxoing was that the body's were a little cheap but should work out fine. I installed them originaly with little issue. It's pretty straight forward if you unsrew the grill to access the clips. Ifound after install that they were not coming on. I checked the connectors and everything seemed to be right so I removed them. after watchong some youtube and readding reviews I tried reinstlling them and " wiggling the connectors , with some limited success. Tuns out that the male pins in the new lights are not bonded in place and push back when inserted into the female socket on my jeep. I re-seated the pins and applied some connecter lube and achived a successful install after 2 more tries. I can accept that these were not expensive light but wanted others to know that what should be a simple install may offer some challanges

They look great off and on . Makes my hero look amazing

First I don't review anything unless its been a min of one month and/or 5 uses depending on how its used, lets face it most things look good right out of the box you want to know what its like after the return window closed. Box/Bag opening and initial thoughts-its well packaged, lights have a plastic wrap on lenses and individual bubble wrap bags, the box is a thin plain brown box, No instructions, utube university is your friend. Lights seem well made housings are thicker then the stockers, the sockets are removable and looking inside solder joints look good, wire is decent size. Install- There are two ways to do this, remove the grill or reach around from behind, I chose to reach around because my winch setup makes it hard to remove the grill completely. First thing I did was disconnect the stock harness-slide the red clip out then depress the clip and pull back to remove, I then attached it to the new LED Signal and tested both.  I have seen reviews of other products not working right out of the box or creating error codes or other issues-I had no issues, they worked as expected. To remove lights- they have clips that extend off the back with a middle finger you simply push the middle finger flush on both clips and slide it out the front of the grill (easier said then done). To install you simply line up the clips and push the signal straight in until you hear the clips engage, they are marked R and L make sure you have them on the correct side or the harness will not reach. The Drivers side slide right in and looked amazing. I wanted a set of these for two reasons-one I feel the stock signals are not very visible and second I have a Black JKU so the smoked lens should blend right in, and they did not disappoint on either account-see pics.  And then like many things in my life the disappointment rolled in, when I installed the passengers side. It did not clip in nearly as easy and when fully installed the top stuck out about 1/4 of an inch-see pics.  I checked everything, and determined it was the way the casting was. It worked as intended but was noticeable. Tip-if using the reach around method you can pop the corner of the grill out where the signals are out of the clip, and that will give you more room behind it without removing the whole grill. Took me about 30 min with taking pictures for you fine peeps, no tools required just nibble fingers- a small flat blade screwdriver may be of service to some, I do have quite a bit of automotive experience so you mileage may vary. Use-I have been using them about 6 weeks now, taking several 5 hour road trips, mild off roading, in 95+ heat and humidity as well as some very heavy rains.  They have presented no problems, no condensation in the lenses, no random flashing or warning lights. I do believe they are more visible in both day and night, then stock.Final thoughts-I am sure you noticed I got this from Vine, because I write these awesome long reviews-hit the helpful button if you found this review was-now would I pay my hard earned side hustle, social monetization or 9 to 5er money for it-I would, I even bought a second set to see if I got a bad batch and the pass side would line up flush like the drivers side-it was exactly the same for my 2017. As such that knocked it down to 4 stars for me, it works but my OCD notices it every time.  But for the cost at time of review under $20, and how well they look and worked for me, had it not been for that they would be a 5 star slam dunk.I will update if I encounter any problems, keep on keeping on.

Easy install. Looks great.

only one of the lights works

Excelente calidad