Chitu Systems 3Packs nFEP Films Release Films 380x260mm for Jupiter/Jupiter SE/Photon M3 Max 12.8 & 13.6 Inches 7K 3D Printer, Thickness 0.127mm

Purchased for the Photon Might 8K.Does not arrive flat packed, not much of an issue, but is much more prone to damage for people not used to handling the stuff.I'm no stranger to fitting FEP or NFEP, but even after using the "bottle cap" method and the manufacturers method when fitting, and adjusting the tension manually, nothing could stop prints from sticking to the FEP. Even adjusting cure times didn't make any difference.When the build plate sticks to your vat even when printing a calibration piece; you know you're in trouble.The official NFEP might be the same price for a single sheet, but its way better value for money when you take into account time, wasted resin and potentially burning your z-axis motor out.Avoid like the plague.

I unfortunately put a hole in the FEP that came with the printer. I have watched a load of tutorials to replace the FEP. I have used one of these FEPS and tried four times to print a test print. Now, I am not saying it isn't my fault but to have four failed prints one after the other is ridiculous.So, I have a question for the seller. Is there a particular side that the FEP is to be mounted, one side has a blue pull off protector sheet, is this the side that would face upwards after the install has finished?Please help as I have prints piling up

As other review states, this comes with poor packaging. Not suitable for newbies as it has not instruction.Fitted this nfep. But it is sticky. Build plate sticks to it even on simple previous perfect print files. Tried a number of different resins with recommended settings. Every print failed. Waste of time and resin

Ottimo prodotto 👍

Añadir un vídeo del montaje sería una opción muy importante por si alguien nunca montó las láminas