12V Remote Control Switch Mini Wireless Remote Switch Dry Contact Remote Control Relay Switch 328ft Long Range with 10A Relay for Motorcycle,Lights,Garage Door,Motor,Fan.(Dry Switch)

The WOODGUILIN, 12v Mini Wireless Switch, works very well. I use it to turn on a light in my garage workshop, from the house kitchen. That's a distance of 50', through the kitchen wall and the garage window.This is in contrast to the first remote I purchased: the MESKLIU, 12v Mini Wireless Switch. The MESKLIU's performance was totally erratic.My only displeasure with the WOODGUILIN is its very sketchy instruction sheet. The accompanying photo shows my notes on how I wired things, and how it works.

Works great. You may find this confusing to program so look at the customer's tutorial video. That video perfect. I was struggling to figure it out in the instructions.

My remote for the the garage door opener (139.53960SRT, RED learning) does not working any more and there is no replacement unit for the remote. Tried a universal remote, same results. It appears the learning function no longer works.I purchased the Woodguilin Wireless Control Switch to solve my problem, and it did. The attached photo shows the installation. Took a lot of research to get the correct installation instructions.Pigtail two wires (red & white) to the garage door opener wall switch that are connected to the Controller switch, white to com and red to no.I use a power adapter 120vAC to 12vDC, 1.5A to power the Controller's input port.To pair the Controller, push button 20 times quickly. Then press the button one time and wait a few seconds then press the remote button once. The Controller and remote should be paired. If they are not, repeat the process. Try to open/close the garage door and it worked.I used low volt staples (Garner Bender MSB-1540) to tack down the wiring.

Setup was straight forward, I powered it with a 5v adapter which worked great. Copy pasta from Tee Zee’s review to get the programming setup below. Other than programming everything went smooth. Actuation is prompt and the range was impressive. Great value for what you are getting.How to change modes:* Note that documentation says green light but it has red light* Reset the current code by pressing push button on receiver 20 times rapidly. The red light will blink 5-6 times or so. It is now ready to resync with remote and change operation mode* You can pick different mode for each remote. Pick a number from 1-20 from the provided guide based on desired mode. Press the push button on receiver that many times. Eg 11 times for auto shutoff after 2m or 1 for momentary connection. Now press the remote button. Light will blink rapidly a few times and now the remote in synced with the receiver. Every time remote button is pressed, receiver will operate according to mode you selected (no of times you pushed button)* Repeat the same for other remote(2). Press the button based on the desired mode and then press button on remote. The two remote can be used to operate receiver in different modes.

This little switch works well, although I has hoped to use a standard 9v battery to power the receiver and switch. Unfortunately, the amp draw for the receiver is 8 milliamps. So, standby will consume an alkaline battery over 3-4 days. This is a latching rely, dependent upon the input power to hold the switch closed and, with that, the total draw jumps to 100 milliamps when ON. Thus a 9v battery will be consumed within 5 hours.

Great remote control wireless switch I lke the lach on and lach off mode , You can program this switch to turn on and off mode time delayed also , Just follow the the instruction provide , I mounted my remote switch on my power bright power bright inverter like the the size of the reciever. Mounted to the inverter with two small screws I had, wired the power to the reciever to the two pos.neg lugs on the inverter. Ran wires from my reciever to the two inveter switch it is easy to tap into those wires inside the the inverter , and I chose the lached mode to turn my inverter on and off it works quiet well with with the key fobs provided . I wrote this review for Rvs off Grid set up DIYERS , This Remote has several capabilities I ordered a nother one should arrive this Monday. We'll I hope in info can be a help Lucky 7 Vet Missouri This is a good dry control I d give 10 stars Bye Now

This worked as a garage door opener but it has opened our garage door twice without input from us. The first time we saw in the morning that it had opened our garage overnight. The next time it closed our garage while we were bringing in things from our car.Another con is that this CANNOT be paired with anything else but the remotes it comes with. We wanted to pair to garage door car remotes and the company advised us how to pair them and that they need to be 433mhz but they would not pair. Tried 2 different sets of 433mhz remotes from Amazon and neither would pair.

Very good and remotes are solid.