V5 J-Head i3 Mega Hotend 12V 40W with 2pcs Hardened Steel 0.4mm V6 Nozzles for Anycubic i3 Mega S X Series 3D Printer Extruder Hotend

It comes "assembled"but I was able to completely disassemble with just my fingers since nothing was tight. i recommend doing this anyway so that you can inspect and ensure it is assembled correctly. The included PTFE tubing was not cut straight on either end. I ordered as a spare so haven't tested the actual heater/thermistor yet but the heatbreak and nozzle are smooth and centered and the rest of the assembly looks pretty standard. The thermistor is a bulb type, held in with a washer and set screw. You will need to wire in your preferred connectors since the ends of both heater and thermistor are bare. Wires are plenty long. It did NOT come with a silicone sock for the hotend even though it is shown in the photos and description. I contacted the vendor and was told basically, "We're sorry, it doesn't come with a protective cover", which I assume means that they know their listing is wrong but aren't planning to fix it. Overall, if you want a standby spare hotend, it is probably an ok deal.

It worked good for the most part. The only issue I have had is when the throat broke inside the heating block.

This is correct print head with the correct wiring, white wire ends...I had a problem with others selling the correct print head, but the wrong sensor and heaters with the black cable ends...

While it looks like and acts like an E3D clone, there is a huge difference is size. If you don’t factor that in, you will need to reconfigure you printer entirely. Had to order a real E3D clone to replace my original broken one. This one was too big.

It was a super simple install, I do find these smaller nozzles clog a lot easier for some reason which can be a pain to remove/replace. But they are required as far as I can tell on the mega S.

As another reviewer has stated, the wires of the product are too long. I was successful at stuffing the extra wire under the cover. Though, it would have been much nicer has the wiring been closer to the length of the original part: somewhere around 65-70 mm long

Works wonderfully. Good length to harness wires as well. Facilitated easy installation even on diy printer

These always seem to be a bit different every time you order one, but this one is unusable in the Vyper in the state it came in this time.The heater core and thermistor wires are both several inches too long. There is absolutely no room to cram these cables in the Vyper hotend assembly. Both cables need to be shortened and spliced back together. Easy enough for the thermistor, not so much for the 40w heater core.2 stars because you shouldn't have to have spare parts, or have to heavily modify the included parts, to get it working with the printer is claims to work with. Only reason it isn't 1 star is because the parts are at least functional.

El producto es como se ve en la imagen, y cuenta con todo lo necesario para poder realizar impresiones 3d

The white cable was out of its place which I believe is the thermostat and the block was all loose which I noticed only after it was all setup. I also taught it came with the Biden tube like all the others I bought.This is my first time with this company and probably the last,

ESTA ENTREGA DE IGUAL MANERA EN TIEMPO Y FORMA ME GUSTO POR LAS BOQUILLAS QUE ME DAN MAS DURACIÓN EN MIS IMPRESIONES.