Comgrow Laser Engrave Enclosure with Vent, Laser Engraving Machine Protective Cover with Eye Protection, Insulates Against Fumes and Odors for Laser Cutting Enclosure Tent for COMGO Z1

It arrived a day early, It was easy to put together and fit my etcher well. I'm very satisfied with the hood.

What I really liked about this enclosure was the price and quality. It was super easy to assemble and very light. I found that a 24" X 24" piece of plywood fits perfectly between the poles and the corner pieces rest on top (see pictures). I hooked up a 4" flexible hose connected to a AC booster fan and vented outside. It works very well to keep all the smoke and fumes out of my workspace.My only complaint is that where the vent hose connects it is very flimsy since it's just a fabric wall. I plan on 3d printing up some brackets and using a piece of 1/4" plywood to give it better support. This is a very minor issue when you consider how cheap this is.I am using this with an Atomstack P9 so there is a bit of extra room inside.

Overall its good, but I can see through it in certain spots after mild use

Used this on a 5w D1Pro laser. Works well. Helps keep the smell out of my workshop.

Easy to assemble and it fits perfectly over my Atomstack A5 Pro+ laser. The exhaust port is on the right, when I would have preferred it at the back, but that was clear when I purchased it. Unlike what other reviews said, the opening for the exhaust hose is a full 4 inches. I had bought a 3 inch hose based on reviews, but I had to return it because it was too small.

Pros: super easy to assemble, great price, comes with vent and vent tubeCons: doesn't work with my Ortur Laser Master 3. I measured and thought it would fit but it doesn't. This sits on top of the frame of the LM3 and doesn't touch the floor at all. If I can't find another enclosure at a good price, I'll probably just add some border along the bottom to help seal in the fumes/smoke.

Its easy to assemble and it work for my engraver.

(Enclosure Review) Installation/building was easy enough. Only thing was that parts list say 8 pieces of parts L/W (same size, different label) but I only had 7. This, in fact, coincides with the number of extensions (7) which they say to attach all extensions to parts L and W. It's not fully enclosed (bottom is open) but it fits nicely over the D1 Pro with honeycomb grate and full leg extension with room to spare. Haven't tried it with the rotary tool, but should do fine. The vent hole is somewhat flimsy; it's a 4" hose adapter that screws into a rubberized fabric. I might 3D print a bracket that spans the support tubes for the hose adapter. No other specific holes for power cord or air assist hose so I'll likely make my own. Overall, decent hood for the purpose and it meets my need.

With the addition of an in-line fan and exhaust hose, it keeps all smoke and fumes out. A lot easier than building one. Blocks out flash and noise I am very pleased with this cover

Muy buena calidad pero un poco pequeña para mi cortadora, deberían de hacer un poco mas grande

Easy to set up, very spacious and you can run a rotary inside this unit. Isn't high enough for a lightburn camera is probably my only real complaint. I'm not sure if I'd trust the windows to protect my eyes but at first glance it drastically cuts down the amount of visible light in the enclosure.

Easy to assembleWorks well will work even better when I hook up the exhaust fan and duct hoseLooks good to