VViViD XPO Dry Deep Black 3D Carbon Fiber Vinyl Wrap Roll with Air Release Technology (3ft x 5ft)

Looks great. It's not as easy to install as you think. Take it slow and use heat.

It works good on flat surfaces but not so well on inner or outer curves. It doesn't stick in the inert most part of the curve. I had trouble getting wrinkles out on outer curves but maybe it was my method. Overall ir has a great look and texture. Make sure to leave extra material on edges as not to have to stretch it on a rounded edge. And don't rush it or apply too much heat, it will melt. 750 is hot enough. I experimented to find the right temp.

I was surprised as to how easy this was to work with. I have never worked with anything like this before. We bought a used kegerator and the previous owner hand painted over the original wood grain wrap and put a sticker on to cover some of the dents and flaws on the door. It’s forgiven enough so that if you need to pull off a bit when installing it still adheres well. It still shows some of the flaws on the door but that’s probably due to my lack of experience doing this. Tip: if you have a bubble or two after you get it on use pin with a blow dryer and maybe a credit card or a large size roll of tape and roll it out.

I am absolutely blown away by this product! It looks just like real carbon fiber and changes in the sun and everything. Gorgeous material! This was my very first attempt at wrapping anything. I did the dash and door trim all around the car. The ease of use with this was awesome and I had every panel wrapped and finished in about 20 minutes. My only experience with wrapping is watching YouTube videos. I got the 3’x5’ roll and I still have about half left. Side mirrors are next!

this is the good stuff, not printed, but stamped. stretches nice, heat it and it reshapes and you can fix your mistake within reason of course. pull on it hard and it will take a lot for it to tear. looks nice, matte finish. very forgiving. do it outside on a warm day or in the sun to help you work it on the piece