12" PWM 4 pin Extension Cable with Black Sleeving # FC44PWM-12BKS

What can I say? It looks nice. It works. Seems thick and well made. The quality is good. It wasn't expensive. All in all, I like it!

Bought these as breakaway extensions on my side panel fans for my Corsair Vengeance C70 case. This works well. I can't recommend this enough for people with side panel fans because when you remove the side panel and you have these extensions running through a back eyelet:1. It gives you more length of travel before you actually have to disconnect the fans, allowing you to work on, or clean the PC without any disconnections.2. If you forget you have them connected, or drop the side panel, it doesn't bend pins when the connection separates. They just slide out. Thus extending the life of your fans, and your motherboard.Definitely recommended for those reasons.

I ordered 3 of these and use them for cable management for my case fans. The sleeving is acceptable, not top notch quality but still decent. You can see the colored wire inside the sleeving if you look up close. They clean up the appearance inside the case since some case fans have ugly cables. Heatshrink near the connections are good and the connection plugs are sturdy.

The pins were bent and so I had to bend them back with tweezers to allow the cable to fit in. It works, but the male end isn't as pictured and is the standard enclosed cable end.Over all, works well, but for the price I'm disappointed in the bent pins.

I recently built a computer for my Fraternity, and this was one of the many "odds and ends" that helped me finish the build.Since my build was in an ATX Full-Tower case, I needed just a little bit more reach out of my fans than the factory cables allowed me.The mesh on the cables is consistent in color and has a reasonably tight weave; however, it pales in comparison to the quality of professionally-sleeved cables. That being said, the connectors are of excellent quality.I'm extremely satisfied with these extension cables!

This 4 pin PWM Extension cable has excellent sheilding and is great when you need a little extra room to run a fan line. This extension cable is very high quality and looks like its belongs in the Corsair Ax1200i cables. The shelding is Quality Braided Jet Black and enough room for any Mid tower and ATX Motherboard. Its well constructed and sexy. Buy this product if you need a PWM Extension.

They are a bit pricey, but the woven covers look and feel very nice.They work as intended and I will purchase a large set again for my next PC build.

Had to buy this as my liquid cooler cable was not long enough to reach from the front of my case to the header near the back of the case on the motherboard. This extender works perfectly. Have been using it for over a year, no issues. Would definitely buy again if the need arises.