UniTak3D Mono X Resin Printer Enclosure Blackout Cover Protection from Sunlight Dust Spill for Saturn/Photon M3 Plus/Photon Mono X 6K,PHROZEN Sonic 4K LCD SLA 3D Printer 11.8((L)x11.8(W)x18.1(H) inch
D**L
No velcro to allow it to be fitted while printing
Needs Velcro added so the front and rear flaps can be held open, so it can be left in place while printing, for ventilation and access to the display.
L**H
Good quality for my Saturn
Does what it says it does and have found the material to be thick and not worried about it falling to bits in a month
R**.
Fits my Elegoo Saturn S perfectly
Bought to cover my Elegoo Saturn S resin 3d printer to completely block out all light while not in use, does exactly what I need
M**K
Tolle Abdeckung
Die Abdeckung passt genau über den Anycubic Mono X Drucker. Die Abdeckung muss während des Druckvorgangs nicht abgenommen werden. Durch die 4 beweglichen Seiten unten, kann man (durch anheben der Frontseite) das Display ablesen. Auch der USB-STICK der seitlich drin steckt, kann an Ort und Stelle verbleiben. Die Luftzirkulation ist gewährleistet. Oben ist ein Griff / Schlaufe angebracht, wodurch sich die Abdeckung leicht entfernen lässt. Bin bisher sehr zufrieden und kann es empfehlen.
A**R
I use it for my Anycubic Wash & Cure Plus
It fits very well over my Anycubic Wash & Cure Plus and Elegoo Satun printers. Keeps the dust off. For storage only, you shouldn't run the printers with the cover on it, the printers could overheat.
Trustpilot
2 weeks ago
1 month ago