Umelee Tesla Car Door Welcome Light, 4PCS Led Car Door Logo Lights for Tesla Model 3 Model S Model X Model Y

Good product, easy to fit and install

Firstly I have to say I am happy with the end result and had these installed in about 15 minutes.However, they are not as bright as the image advertised comparing them to a lower resolution product...they ARE the lower resolution product, but I did expect this to be the case.The other thing is they come with cables that you won't need and they are just excess....maybe required for different cars, not the Model 3 2022 refresh.The pins in the light unit need to be adjusted forward by about 1-2mm or they will not enter the female connector in the car. The first attempt pushed the pins against the wall of the male connector and I needed to carefully adjust them back and I then figured out the problem and took action on the rest of them.Overall a nice addition to a lovely car.

I thought this was a great product, at night they are really bright which looks fab. Model s p90D where the current ones are on the back doors I found if you pull back the door cover and install in the plastic covered blank plates they’ll point down like the front. Otherwise the rear ones point back at a 45 degree angle. Although to do this you’ll need to use a knife to tear through the plastic. You then take the cable and pull it further down to meet it. The front just replaces the current light. The extra wire in the bag for each light wasn’t needed for mine. East to fit, bright, overall quite impressive. Fitted without any issue

Bought these to replace my drivers door puddle light that had failed.I’ll keep this short and sweet - these are WOEFULLY dim in comparison to the set I had before from another manufacturer. I mean you can barely see them in the dark! They are around 15% of the brightness of my previous set.Don’t waste your time nor money.Returned.

Brilliant lights to add a little something to your Tesla. Looks so good I brought another set for a friend. Easy to fit and looks fantastic.

Delivered on time. Fitted today, took no more than 5 minutes to fit all 4. Just checked them now and they are fab. Bright, clear, perfect.

I already ordered the motrobe brand that sells only 2. That one is at least twice as bright as this one.

These are actually amazingly good for the money but a little tricky to fit and get right. I made a few mistakes before I figured them out so hopefully these tips will help others...1. There is a small lever on the side of the round projection lens module inside the light body which you can access via the cut out slot on either side (just behind the transparent front cover). Use this lever to rotate the protection to your preferred angle BEFORE you insert them into the car door.2. If you do need to remove these lights from the door put a towel on the floor first in case they pop apart to catch the pieces and avoid getting the lens scratched. Use a flat blunt tool like a spudger on the long edge of the light NOT on the short edge (if you try and use the short edge they will almost definitely come apart).3. If they do come apart, insert the metal cooling block in first over the circuit board, then the rubber o-ring, then the lens, then click the transparent cover back on. Take care to work out the correct orientations as the metal block and transparent cover are not symmetrical.4. The Tesla plugs on my 2015 model S wiring loom do fit straight into the lights without the extra leads, however the contact pins inside the lights are not aligned properly out the factory and need to be carefully tweaked so they are the correct height to slot into the Tesla connector. Mine were way too high, I managed to adjust them by gently pushing them down closer to the light body with a screwdriver. Don't force the plug in if they don't line up as you will bend and/or break the pins.These do require a bit of skill but they do look great in my opinion.