Parker2GF-3-pk20 45 Degree Fitting, Flare, Brass, Flare Gasket, 3/16" (Pack of 20)

Easy to use and no more leaks.

I tried to tighten a break line to the extreme. Still leaked. Added one of these and "Problem Solved". Price is right for the amount of "head ache" it solved.

After replacing all the brake lines on my 1990 jeep I had a few flare fitting that just would not seal.Even on the pre -flared lines for the clutch. These washers fixed all of them.You got to be sure you center the washer over the female part of the flare or it might restrict the flow and leak.Great product to have in your tool box.

Replaced all the brake lines with "finelines" stainless steel only to find several fittings leaked. These stopped the leaks, the brass makes a much better gasket type seal than the raw stainless.

Seals it n soft very easy to tighten on hard lines in tight spots....but green fluid makes shifting hard.....need brass..... End up getting some finishing washers And had to cut them with the pair of scissors which didn't work the 1st 3 times.

Description says pack of ten. I recieved exactly one flare gasket.

The product looks good, I think it will work well for sealing leaking stainless steel brake lines at junction points. However, I received only one gasket. I am requesting a replacement order because it is advertised as a pack of 10 gasket flares.

great advice, could not stop brake line from small leak, these did the job....excellent