Rock and Roll Bed Bench Compatible with Type 2 Rear Engined Van and Bus Splitscreen Baywindow

If you like Rubix Cubes you'll love this.Overall it's pretty well put together, seems all the parts are there, however, it does not look like the photos where the lower seat supports are located most importantly there is no (NO) diagram of the hinge mechanism itself.. I'm a pretty good engineer and I'm still having a hard time here. Luckily I have a nut-sert gun & the right supplies 'cuz this needs some real work & thought to get together.Really... Instructions please.I'll leave it mocked up and raise the rating if somehow instructions magically appear....

The bed itself is fine but there were two major issues. First, there was a hold drilled out of alignment which when the bed was put together would not allow one of the side braces to go up and down properly. Not a terribly difficult fix but still annoying.The bigger issue is that the bed came with absolutely no instructions at all on how to assemble. Just a pile of parts and a big bag of screws, nuts and washers. I tried contacting the seller to see if they could send me a link to the assembly instructions but no luck. So instead I just had to keep looking at the pictures in the ad and figure it out as I went along. With directions you could probably put this sucker together in 20 to 30 minutes tops. Without, well.. I was ready for a beer by the time it was done.On a side note, some of the parts fit together a little loose so if you know how to weld, you will be much better off, otherwise plan of getting creative and adding some extra self-tapping screws to hold things together.Oh and don't forget you still have to deal with actually installing the bed into your automobile. Mine went into a VW split-window bus and required me to make some special brackets to hold everything properly. Again, a welder helps a lot here.