ChannellockPlier Tongue Groove 12 Utility (GL12)

I use the often and like the shape , adjustability, and comfort.

I use this style of chanel lock in my work as a plumber.

A good companion for the 10” .

These are my EDC pocket pliers. Come in handy ALL THE TIME. Take some breaking in for the adjustment grooves to loosen up, but same Quality as Always from Channel Lock. 6in are great for small fasteners, if needing for bigger than 12-15mm, I'd go with a bigger size just because of wrist/hand comfort. Work great! This is my 2nd pair, lost my last pair at work so somebody found a great pair of pliers that day lol. I do recommend these to add to your tool box/bag/and EDC pocket if you're always fixing something like myself! 👍

I loved the product…I should have gotten a smaller pair also…these are a bit large for tight spaces

I’m a plumber and these little guys get used often. Over time you typically leave a pair of ‘babylocks’ on top of a water heater or under a sink or just misplace them and they are invaluable so having multiple sets is so worth it. These can be used for toilet mounting bolts, tank bolts, supply lines, gas control valves, shut off valves, and so much more. They offer a different angle than the other two types of 6” channel locks, so it’s recommended you buy all three. They are priceless and worth their weight in any tool bag.

Looks good free from defects. MERICA BABY!

I am buying these to replace an identical pair That I've been abusing for the past five years. I work as a millwright, and I put these pliers in my back pocket every morning, right after I put my soapstone and tip cleaners in my left pocket. The uses for this tool are very much limited only by your imagination. I have used these as a light hammer, light pry bar, spud wrench, press ( for pins and roll pins in torches), a small vise, clamp, a chipping hammer, as tongs for hot parts fresh off the torch; and I can open them all the way to grab 6 pieces of 1/2" plate; I use them to grab metal plates to slide far enough off a stack to hook a beam dog to, to break slag off of torch cuts when a grinder isn't handy, to knock spatter off of wire welds, to insulatively change welding rods when welding in the rain- Disclaimer: YOU should NOT Do this, to remove or install cotter pins in chains, to press side plates onto chains, to change regulators on torches and welders, etc,etc,etc. These $10 pliers have paid for themselves many times over and I'm still waiting for my first pair to wear completely out. The headline says it all folks, You will not find a better pair of pliers for edc; and that's precisely why I'm replacing a worn out pair with the same exact model.

First i bought a wrench but it was sliding and can not hold the pipes well. Then i ordered this and it worked great, no sliding, fixed the pipes easly. İt has different levels and easy to change .Great product.

Muy buen agarré, de construcción sólida, aunque no es del todo ergonómica para mi mano, pero permite hacer bien su función, ha aguantado uso y abuso sin problema.

I operate wire EDM machines. We had a round stock detail that needed to be tightened to a bolt, on a jig. The round stock was about .010" to .020" heavier than the advertised jaw capacity. I was worried they wouldn't fit. I was wrong, they had enough capacity with some wiggle room.I had a smaller pair of cheap toung and groove pliers that need replacing, and I will definitely buy Channellock brand when I do.

Waiting on a delivery date was a few weeks. But this is a quality genuine tool, I use it every day plumbing.

quality is only okay