4FT Vapor Tight LED Light Fixture, 60W/50W/40W Wattage Selectable 7200lm 5000K 100-277V, 0-10V Dimmable Vapor Proof LED Light for Car Washes Parking Garages, UL Listed

Good fixture bought the 8 footers as well clean lighting

These are so much better than the old school lights. We needed to replace some bulbs for the old fluorescent ones in the barn and instead decided to start replacing with LED. Great decision. Theses are much less bulky and so much brighter there’s no comparison.

My electrician recommended these and then installed them in my 40’ storage container. They are extremely bright and work great. Being water proof they continue to work despite the leaky roof and heavy rains. 10/10 would recommend.

I mounted this just above my Jet wood lathe and it gives off great light. I bought it because of its dustproof cover, and I think the heavy plastic cover will be less susceptible to breaking should a bowl come flying off.

I installed these in my greenhouse that we use all her round.They produce a TON of light!I highly recommend these!

The product arrived in a few days and I'm impressed by how well built i is. I like the fact that it includes all the screws and wire nuts to connect it to the electrical supply. I attached a 0-10V dimmer and thought that at 0 volts that the light would turn entirely off. I doesn't but it get very dim. I'm going to test the line voltage to see if indeed I have a 1-10V dimmer instead of the 0-10V like I ordered separately. Anyway, I'm using it in a bathroom at a mountain cabin that can have high humidity and the overall seal of this unit makes it an excellent choice for illuminating the entire bathroom without the fear of moisture getting in a fouling up the light fixture.A+++ I would buy another one for any high humidity environment! A+++

I am not typically a shopper who chooses to complain but I have had such a poor experience with these lights that I wanted to share some feedback in the hope that other customers may benefit. The short story: I purchased two 4 packs of lights for new garage construction. The first light was opened and installation hardware began to be installed before I noticed that the LED control box was not secure. Upon closer inspection, all four mounting posts were shorn off (likely from the over-tightening of the mounting screws). Not one to easily give up, I thought that may have been a one-off issue. The second light package was opened and the same issue. I know these are not the most expensive lights but I was hoping they would arrive undamaged. Returning both and back to the drawing board for my interior light needs. Sigh!

These lights have to be wired which isn’t included. Not an issue for some but could be for most. They’re manufactured in China where quality control isn’t their strong point. When I wired these I check all of the manufacturers connections and found several issues. I found in at least six out of twelve fixtures I installed having one or two wires (hot, neutral and ground wires) not connected, but all were an easy fix, also the LED starter in 4 fixtures weren’t securely attached to the frame (again easy fix for a competent installer). I installed 12 of these fixtures so if you’re ordering one or two you might get lucky and not have any issues at all. I had one other issue with the quick connect clips that are used to wire the light into your electrical system. The first three fixtures the clips gave me problems so I omitted them and hard wired all of the fixtures using wire nuts. With all of this said, they give off nice even light and gives you the ability to adjust the light intensity with 3 brightness levels but they are not a plug and play light fixture. I would suggest you look for a UL tested fixture. But did I mention, they give off nice even lighting. I’m looking for a positive.