5pcs LED Indicator Light 12V 6mm 1/4" Waterproof Metal Signal Lamp Power Work Light for Pilot Dash Car Truck Boat (6MM, 3-Blue)

The lights arrived fast, and immediately put into service. These are perfect for my intended use - as indicator lights. Small, and unobtrusive - bright enough to see in daylight, but not glaring or annoying. A previous reviewer stated that the mounting surface must be pretty thin - and I ran across that situation, and instead of using the supplied locking nut, I secured the light in place using a small wire tie. The front bezel is quite small, so if you're drilling a hole for this light make sure you drill the for exact diameter, which I believe is .25". I recommend these lights.

They are very dim. For a 12v LED it should have been quite a bit brighter. It barely shines at all. Do not buy!

I am disappointed in the brightness of the lamps and the. I did not install yet but I am looking for a spot to apply the lamps in to utilize the size and the low amps to operate. I really wanted a much brighter Light.

These lights are awesome! I am using them As component/dash lights on a custom motorcycle build! They’re super small and fit my application perfect! They are plenty bright to be seen In direct sunlight. But it’s not a sharp beam of light glaring straight into your optical stems while riding at night, It’s almost a soft diffused light with a very wide viewing radius! I loved them so much I bought more .. for no reason !

The media could not be loaded.  Easy to use... drill an appropriate size hole , slip it through and use the provided lock washer and nut. Then it’s just a hot and a ground wire... use what ever switch you need. And you’re done!

I have 10 of these lights installed on an outdoor enclosure. 2 have failed so far after about a month. After inspection, it was discovered that the LED can be removed by pulling out the grey bulb holder from the back. The connections to the resistor and LED were corroded and broken. There is no water protection on these. I have applied a layer of clear RTV over the front face to try and keep water from seeping inside. I like the size and brightness, but you get what you pay for too.

Used to construct a boat electrical switch panel. Perfect for the application. Only negative is a 20% failure rate so far. Out of 10 only 8 are working. One was DOA and the other failed in less than 12 hours of use.

I used these for some test boxes I created for my technicians, these work (illuminate) really well and are super easy to work with. FYI, these work well on slightly lower voltages, I.E. a 9-volt battery. When I build more boxes I will be buying these again.

I haven't got to put them in yet but they appear to be exactly what I was looking for, They are very well constructed And Put off just The amount of light I was looking for.

i built a faux guitar amp box curio cabint and used these as indicator light for power and interior lights on

used on electrical boxes to show power on or off

Very nice, small, well built, perfect brightness for an indecator