Denso 234-4157 Oxygen Sensor (Air and Fuel Ratio Sensor)

Perfect upstream air/fuel sensor for my 1996 Toyota FZJ80 Land Cruiser. The wire plug fit right into my truck's plug, and the included gasket and sensor mated right up to my exhaust. Easy install, literally took me fifteen minutes.Two suggestions: don't touch the sensor pod itself, make sure you got no grease or Loctite on it; and, 2 get the Irwin bolt remover kit before you start the job because your original nuts holding in the sensor probably don't even look like nuts anymore. They're a rusted mess. Good luck.

1996 land cruiser, part fit perfectly, solved CEL

Don't buy Toyota branded version - this is what you want! I have a 1997 Toyota Land Cruiser and both 02 sensors went out - after alot of research I determined that I needed both the Denso 234-4147 (this one) and also the Denso 234-4153. Together, they fixed my problem for far much less $$ than the Toyota branded version!

Perfect fit in the exhaust as well as the plug. The nuts holding the original sensor were completely rusted but was able to get them off. You should replace the nuts and use anti-seize.

It fits perfect my Lexus LX450. It can also work for 1995 to 1997 Toyota Land Cruiser. Don't buy it from Toyota or Lexus dealership they will charge a lot of money. This is the same OEM that Toyota and Lexus use but you are getting it cheap because Denso is selling it through retailer and not through Toyota and Lexus dealership.

About the same price as cheapo Autozone sensors, why not just go with OEM quality? replaced the sensors on my 1997 LX450 with these and plug and play.

This is an exact match for the Toyota part. It fixed my 420 code. 1996 FZJ80 Land Cruiser

Toyota factory quality at 1/3 price and improved mileage helped me pass inspection