Body-Solid Powerline (PPR200X) Adjustable Power Rack - 18-Level Strength Training Heavy-Duty Steel Frame with Safety Rods and Chin-Up Bar for Home Gym

Review written two days after receiving power rack.*The small posts (the ones that hold the barbell bar when doing bench press or squats) and large posts (the bars that provide you the safety when bench pressing or squatting) easily get scratched when a threaded barbell bar comes into contact with them, but this can be avoided by either putting tape on the posts or putting on them FOAM NOODLES (shown in the picture uploaded by P. Stubbs).*I measured each of the two small posts is 9cm (3.54 inches) and each of the two large posts is 85cm (33.5 inches). So if you buy FOAM NOODLES (I will) you need: (3.54 + 3.54) + (33.5 + 33.5) = ~74 inches.*I measured all four posts have a diameter of 25mm (= ~1 inch).-So, use these measurements to wisely purchase foam noodles, which I strongly suggest you do or else you'll scratch the posts every single time the bar comes into contact with them.*The power rack comes in three boxes. Box 1: 48lbs, box 2: 46lbs, box 3: 43lbs. The first box is ~7 feet long, and the others ~4 feet long. If the UPS truck does not give you THREE boxes then don't accept the package. I only received two boxes on delivery day and on the next day I realized I was missing one box but that same day UPS delivered it - UPS somehow screwed up. I contacted Amazon support that day through chat and the representative immediately scheduled a replacement sent and a pickup (to get the two boxes from my home) no questions asked, but as I was chatting with the rep., UPS driver rang my bell - and there it was - the missing box.*Assembly was easy but it took me ~2hrs because I assembled 98% of it alone. With someone's help it would have taken ~40 minutes.*I followed the instructions to assemble and found them to be easy to follow; others complaint they were confusing but I strongly disagree with them.*There are a total of 26 HEAD HEX BOLTS included in one bag ranging from 65mm in length to 75mm, so it took me a few minutes to measure them and organize them by length, so I wish the bolts had been separated.*No TOOL is provided to fasten the head hex bolts, but luckily I had the ones that came with the bench press I ordered a few months ago. So, make sure you have a tool to use for this type of bolts.*The parts are: (4) Rack frames, (1) base frame, (1) pull up bar, (2) large post, (2) small post, (2) pull up frame, (1) rear frame, (1) left base support, (1) right base support.*A standard 72-inch (6-feet) barbell bar was the perfect size for this power rack; Anything shorter or longer is NOT appropriate.*When doing pullups the power rack doesn't shake at all (very sturdy).-I LOVE this power rack. It looks great and after assembly it feels very sturdy and safe. The pullup bar is great. Once I add the foam noodles to this rack it will look even better and won't have to worry about scratching it either!5/5 stars.CON:*The paint CAN come off easily on the posts, like a lot have complaint on the reviews, but the FOAM NOODLES or TAPE can fix that problem right away so get them!*WARRANTY Registration Card: "You must return this registration card to POWERLINE within 10 days for this Warranty to be valid." < ----------------- That right there is absolute bull****. It's been a week since I ordered this... I should downgrade the value of this by 1-star for this unethical thing, but I'm so happy with the rack that I won't even bother sending this stu**d card. Very unethical of them!

First off, the instructions that were included covered everything in detail. It appears they are shipping this rack with a full instruction set now. So, I'm guessing the company listens to their clients, which is always a good sign.I purchased this rack to replace an old system and have been quite pleased, especially at this price point. This rack is primarily used for squatting, DL partials, pull-ups, zpress and paused bench work. The amount of accessory work that can be done with this thing is far to long to list. I frequently have up to 335 lbs racked at squat level without any issue. The rack feels quite sturdy in that regard and I feel confident putting more weight on there as I progress. I've done DL partials with 225 lbs on the safety pins and they seem to handle it quite well.My biggest concern with this purchase was the pull ups. There were some good reviews on this, but as always, I'm a bit skeptical. @ 190 lbs body weight with a dip belt and a 35 lb plate strapped on, the pullup bar is supporting roughly 230 lbs and I'm not getting any wobble on the rack. It still feels really solid. The only time the rack wobbles is if I adjust the barbell while it's weighted to center it. Then, there is a little wobble. The bar doesn't need to be dead center, I just need to learn to be less OCD with that while using this rack.As several have mentioned, the paint wears off incredibly fast. My rack is indoors, so I don't have any concerns about rust. If this is a concern for you, I would recommend wrapping up the pins with a small piece of cloth and taping it in with some electrical or medical tape. As far as aesthetics are concerned, you want people to notice that you use your rack... you may as well toss the touch up paint ;)I would make one possible suggestion for those of you, who like me, move the pins a lot. The pin holes are not marked or labeled, so I wrapped a piece of electrical tape just below the pin holes that I use for my most common lifts as markers. This makes adjusting the pins a quick task.All in all, I am very happy. I would highly recommend this rack for beginner and intermediate lifters. Now go squat!

Robust, strong and so far, worth every rupee I spent on this.

Acquistato per la mia Home Gym nel mese di Aprile 2015, dopo diversi mesi di utilizzo intensivo il prodotto si dimostra di ottima fattura (made in USA). Nessun problema riscontrato in fase di montaggio, in quando le istruzioni di montaggio a corredo sono molto chiare ed esaustive (si può montare tranquillamente da soli, con un martello due chiavi del 19 e una scaletta). Molto soddisfatto del rapporto qualità prezzo. Consigliato

Nachdem ich zunächst nach einer stabilen Drückerbank gesucht hatte, die mir entweder nicht stabil genug oder zu teuer waren, und anschließend nach Hantelauflagen gesucht hatte und nicht wirklich fündig geworden bin, bin ich schließlich auf Power Racks gestoßen.Lange habe ich verglichen.Zunächst dachte ich an den Pro Power Cage BCA 08, der aber ca. 400 Euro kostet. Neben dem um 110 Euro höheren Preis war hier der Nachteil, dass die Bauhöhe 218 cm beträgt. Genau die Höhe meiner Keller Decke. Eine Montage hätte nur funktioniert, wenn ich die Klimmzugvorrichtung falsch rum eingebaut hätte. Bei 1,90 m Größe hätte ich mir dann aber den Kopf gestoßen.Weiter dachte ich dann an das GPR388, den "großen Bruder" vom PPR200X. Fast die gleichen Maße aber 30 kg schwerer und entsprechend stabiler.Wegen der vielen positiven Bewertungen und dem unschlagbarem Preis habe ich mich dann für das PPR200X entschieden. Ich wurde nicht enttäuscht.Spät abends bestellt erfolgte die Lieferung erfolgte nach 1,5 Tagen. 3 Pakete, jedes ca. 20 kg schwer.Für den Aufbau habe ich etwas länger als die häufig angegebene Stunde benötigt. Insgesamt liegen 4 Schraubenlängen bei. Zum Ab- und Wiederaufbau sollte man also die Anleitung gut aufheben. Alle Teile vormontiert, ausgerichtet und schließlich feste angezogen. Werkzeug: Knarre mit 19er Nuss und 19er Schlüssel.Aufgebaut ist es sehr stabil. Es wackelt nichts. Klimmzüge sind wegen meiner Kellerhöhe nicht wirklich möglich. Aushängen aber super möglich.Die Einstellmöglichkeiten sind mehr als ausreichend. Eine 200cm Hantelstange wird benötigt. Die Sicherheitsstreben sind aus Vollmaterial, ebenso die Hantelauflagen. 120 kg habe ich bislang aufgelegt. Kein Problem. Ich hatte nie das Gefühl, dass irgendetwas nicht hält. Auch eine schwungvolle Ablage der Hantel ist kein Problem.Vorteil des Power Racks gegenüber Drückerbank oder Hantelauflage: Neben Bankdrücken, Schrägbankdrücken sind auch Kniebeugen drin. Und das Ganze mit Sicherungsstreben! Die Latzugvorrichtung habe ich noch nicht gekauft. Nachteil hier, dass auch die Länge entsprechend größer wird.Klare Kaufempfehlung. Viel Spaß damit.

prodotto ottimo che va as integrare una piccola palestra in casasolido e compattomontaggio rapidomolto stabileper ora soddisfazione massima per un utilizzo medio-alto

Die Lieferung ging recht zügig. Der Aufbau war relativ einfach. Das Rack macht einen stabilen Eindruck. Toll geeignet fürs Home Gym. Man braucht allerdings eine passende Langhantel - hierauf sollte beim Kauf geachtet werden. Auch die Klimmzugstange macht einen soliden Eindruck und hält einiges aus. Bis zu 150 kg sollten hier kein Problem sein. Preis Leistung sehr gut. Alles im allen Top. Vielen Dank