Ultra Dark Toner Powder Pack of 3 for 12A / 15A / 49A / 53A Canon FX9 Toner Cartridge Single Color Toner (Black)

" IT'S EXTRAORDINARY AND MIND-BLOWING QUALITY. PRINTS OUTS FROM HP LASERJET P1108 PRINTER AND PHOTOS ARE OF MAFIA 2 PC GAME POSTERS. ITS VERY DARK QUALITY OF PRINTS, VERY SHARP AND A LITTLE SHINING IN PRINTS. MUST HAVE PRODUCT AND BEST AVAILABLE ALTERNATIVE OF ORIGINAL COSTLY TONER. I PREVIOUSLY TRIED PROFISSY TOO BUT IT WAS NOT DARK AND QUALITY OF PRINTS WERE NOT SATISFIED BUT THIS ONE IS WINNING.. O LOVE THIS PRODUC. RECOMMENDED 100% THANKS "

Good product

The print quality was good. I was looking for a good toner for my DTP printing work. I tried many different toners. But I found this one is good. Print quality is good on Master Paper. It has not been tested yet on butter paper. but only one issue that is packing. Packing was not upto mark. Seller kindly take it seriously.

Very light prints , proffisy 12 a refill powder is way far better than this .

Ok

This is a lot less expensive than buying an entire cartridge. Basically, you fill the empty cartridge with the black powder in the canister. After refilling with this powder, my laser printer produces clear, sharp prints. Drawbacks: it's messier than just installing a new cartridge that has been refilled at a factory. The very fine, light weight powder spreads easily, so put some newspapers around to catch any of the powder that usually spills. For anyone who has experience of repairing stuffs this is a great purchase. You need a Phillips screwdriver, a small Flathead electronics screwdriver, a pair of needle nosed pliers and a funnel. Refill takes about 15 minutes to perform and is mess-free if you're careful. For your guidance lot of videos are available at YouTube. One hint: don't overfill your cartridge. You may be tempted to stuff as much toner as you can in there. If you put the cartridge into the printer and the drum won't spin you've overfilled it. You'll have to dump some toner out. Too much toner creates friction on the green drum and prevents printing. You should only need about one bottle (120 grams) for the pack in cartridge for one time refilling. Use paint brush after you're done to clean up the minor toner mess around the hole and surface of the cartridge. You need to be a little handy, detail oriented, and patient. If you're in doubt, buy a compatible cartridge. It costs around 450 to 600 Rs. Never again would I buy another toner now that I know how to do it myself.

Very bad product waste of money and time, don't don't bye this product, this is very bad quality magnetic toner, very less magnetic power thats why excess toner compartment of printer is getting full within 20 prints.

good