Yard Butler Manual Lawn Coring Aerator, ID-6C - Lawn Care Tool for Aerating - Long-Handled - Power-Coated Steel Construction - Comfortable Cushioned Handles Garden Tool - Easy to Use

This aerator did a great job for a 7' x 25' yard. I'm a newbie on maintaining lawns so I found out aerating is ideal for dead patches of grass that are compacted. I've read many articles, blogs and seen videos on how to get that "golf course" lawn look and aerating was one of the key factors when you have hadr soil. Although my lawn (Tall Fescue) isn't "golf course" grade, yet, it does look a lot better than it did a year ago while hiring a lawn company to take care of it. Since firing them my lawn has looked so much better. My lawn had dead patches due to rain water constantly running down certain paths over the years after each rain fall which caused the lawn in those areas to be compacted. I used this on my lawn and it pulled up the plugs very easily. This was done on dry lawn so I'm sure it'll be even easier on wet soil as others have mentioned. I cored about 8 inches apart throughout my entire lawn. I then raked the plugs of dirt back into the lawn to break them up and keep the nutrients in the lawn. If not, it'll look like a group of Geese dropped turd all over the place. After raking, I applied the mineral Ironite with a drop spreader and lightly watered the lawn. While using the aerator, I applied even downward pressure and made sure not to go in on an angle to avoid any damage to the unit. Since there are so many negative reviews on the poor construction of this unit I was careful when applying pressure. It feels like a strong piece of equipment and it definitely held up to hard compacted areas. At one point a rock became stuck within one of the cores and I noticed no dirt coming up through it. I used a screwdriver and a hammer to dislodge the rock and it worked without issues. Make sure you wear gloves! After I completed the work, I had a blister in my palm from constantly grabbing the handle to help push and keep the unit straight but it was well worth it in the end. I'm happy with this unit and I'm already seeing results after a couple of days. My lawn will look even better within a week. Going forward, I will aerate every year but not as vigourous to help nutrients, water, oxygen and fertilizer reach the roots in the Spring. Word of advice, cut your lawn high (3 - 4"). It'll help retain moisture, help keep weeds out and look greener/healthier. I highly recommend this unit.

This tool works great to use at the edges of my lawn where the grass is hurting because of watering restrictions. The plugs go deeper than the machine aerators, was easy to use and sheds the plugs very efficiently. To cover 50 square feet took me less than 20 minutes. I used a wood dowel to clean out the last plug.

I wasn't up for spending the money on renting a gas powered aerator, not to mention I would have had to wait for a couple weeks before one was available, so I opted for the Yard Butler coring aerator after being unable to find one in my local hardware store. The tool worked great so long as mostly clay soil that I call my yard was well soaked, but had some difficulty when the soil was dry. To get maximum results, I would run the sprinklers for about 20 minutes (until I got standing water on top of the bare spots) and then let the water soak in. Anything less required pounding the spikes in with a dead blow. Three weeks later, I can say that the results are dramatic. The patchy spots have almost entirely filled in and the already green areas are much fuller and lusher than they were previously. I attribute this purely to better water penetration and looser soil as I did not add any fertilizer to the yard despite the recommendations. It took about two hours (including watering time) to do my 2,500 square foot yard that is laden with some nasty roots that a previous owner never removed. I found that with proper motivation (that dead blow again), the aerator would make nice round root cores in addition the the the soil cores that I had left behind when done. While the results speak for themselves, the effort required to use this tool is not trivial for a moderate sized yard. I found that the clay soil would become lodged in the spikes if it was too dry which could be reduced if the spikes were slightly tapered. I am guessing that tapered spikes would probably drive the cost way up from what it is now. I also found that proper knee placement is essential to coming out of the yard bruise free (I did not), but this is subject to the operator more than anything. All in all, I can't complain though. The tool operates very well for what it is and will make your yard much more healthy than it is now. It is well constructed and take good beating (literally). I cannot recommend the tool to those that dread the manual labor involved with yard work. For those, I suggest hiring a professional who can bring out the gas powered tools or a teenager who will deal with the punishment for some spending money. For everyone else who enjoys the fruit of their labor, I can provide a hearty recommendation.

I bought the Yard Butler Manual Coring Aerator with two hollow tines. It was a recommendation from Chat GPT. It is made of powder coated solid steel, not thin hollow tubes. It is very easy to use because it has only two tines so it is possible to push into the ground. It worked perfectly. Each time you push it into the ground it pushes the previous core out of the top. I’d give it six stars if I could.

I purchased this with the expectation it wouldn't work and I'd need to hire a professional with a gas powered aerator. I waited until we got a decent rain and then I gave it a shot. In the parts of the yard that got a good deep soaking I got nice long plugs. In the drier areas I only got about 1-2 inch plugs. I bought a metal spike to clear the cores but I never needed it. I have pretty heavy clay soil so I was supposed that it didn't bind up. I think the best advice I can give for this tool is to wait until it rains enough to really soak the soil. I also tried not to force this tool into the soil. If it felt too hard I just moved over a few inches and tried again. The metal cores are sharp and the end and the step in after a couple inches to help prevent clogging. The design works very well. My yard is reasonably small so it only took me 30 minutes to do the whole thing. If you have a large yard I'd plan to use this for a spot treatment or to hire a service. So far my lawn is looking healthy and the old cores have almost completely broken down. I'll probably plan to do this once in the fall and once in the spring. Update: the first season I used this aerator it worked perfectly. The next two seasons it has been far less effective. I've waited for a deep rain each time I've tried to use it but now mud is packed into the cores. I've used a metal spike to clear the packed clay but usually I get only one or two steps before it's clogged again. It's ended up serving more as a spike aerator but that doesn't help with the compaction in my lawn. Perhaps the cores need to be larger but regardless, I've been less impressed with this aerator lately.

I've used it several times in the past 6 weeks. I get my entire lawn core aerated annually by a gas powered machine, but I bought this for the following uses: * The soil gets compacted at the gate from the front yard to the back yard. It's a funnel so all of the traffic goes in a narrow area, and it especially gets compacted when I have a big garden project that requires wheel barrows. I used it here when it first arrived and it did great, and then used it again after a big gardening project. * I have St Augustine grass so in the fall there are a few areas that get brown patch. This year, on those 3 spots I used the aerator and then top dressed with leaf mold compost prior to brown patch season. Should prevent the brown patch and help get some organic matter into the soil. * The darn cinch bugs killed a couple spots in lawn along the sidewalk. After killing off the cinch bugs, I used the aerator in the dead grass and top dressed with leaf mold compost. The core aeration will help get some organic matter into the soil while the St. Augustine grass fills in the compost. Positives: * It produces nice sized cores both in terms of depth and diameter. * It's very simple to use. It's mindless work and one of the few times being overweight pays off. * It's very sturdy and well constructed. Feels like something that will last many, many years. Negatives: * It's a lot of work so best for small areas. Rent a gas powered core aerator to do entire lawn or hire a contractor. * The last core stays in the tool so you need to push it out with a screwdriver at the end of the project.

I purchased the Butler Manual Lawn Coring Aerator to help improve my lawn's health, and I’ve been very impressed with how well it works. The tool is sturdy, well-built, and surprisingly easy to use for a manual aerator. It pulls nice, clean plugs from the soil, which has helped loosen up compacted areas in my yard. After using it, I noticed better water absorption and healthier grass growth in just a few weeks. It’s also a great alternative to renting a powered aerator if you have a smaller yard or prefer a more hands-on approach. The dethatching effect is an added bonus too—makes it a great 2-in-1 tool. Definitely a worthwhile investment for any DIY lawn care enthusiast. Highly recommended if you’re looking to give your grass a boost without breaking the bank.

There seems to be many reviews here from people who report that this tool bends. How did you manage to do that? It's made pretty solid, looking at the construction. I asked a friend who does welds and fabrication, who said the same thing. I'm a 5'8 male at around 185lbs. In order to bend this thing, I'd have to turn it into a pogo stick or lean against the thing, trying to use it as a wall. If you use this tool correctly, it's not going to bend. Unless you're getting a different build of this thing, I cannot see how you bend or break this without using it properly. Now, the part that matters: the cores or tines. There was a review posted about 6 months back from a guy who had the "clogging" problem I experienced with this in an area notorious for clay soil. As I've got more serious with lawn and garden stuff, this has come true. My lawn is mainly compacted, clay soil. When I first started out, the ground was about 36 hours removed from a solid rain. I got clogs in one of the cores. Cleaned with a screwdriver and the same thing happened about 5-10 plugs later. I looked on reviews here for those who didn't just throw the thing out or return it and this was helpful: http://www.amazon.com/review/R2ES9FU92PWQUX/ref=cm_cr_pr_perm?ie=UTF8&ASIN=B000CZ30C8 The core is tapered as you can see in the picture and if you own it. Remove about half an inch using an angle grinder or dremel with a cutoff wheel, making sure to maintain the angle and leaving around 0.5-0.75 inches of the "smaller" part where the dirt would enter into. This helped a ton on the side that kept clogging up. However, I still got clogs, just around every 20 plugs now. I inspected the inside of the core, only to find that there was not a smooth cylinder, but "bumps" on the inside leftover from the welds. On a different product, similar in design but from a different company, a person suggested using a metal file to smooth these out. The bumps were thankfully close enough to the tip that I could take a grinding stone (aluminum oxide bit you'd use to grind or sharpen a blade) and smooth these out. About 5 minutes of getting a small bit in with the Dremel did the trick. I smoothed the burrs out with a file and tried it out with success. I did about 100+ plugs after some rain last night and had no clogging on either. I'd recommend to Yard Butler that they smooth the insides out to stop this from happening. Also, as noted, doing manual core aeration is hard work. Renting a machine to do this from a shop is usually $60+ for 4-8 hours, and you'll need a truck to transport it; I've read that some Home Depots also have machines to rent but call them. Otherwise, this tool is doing what I bought it for. It's perfect if you want a workout and don't mind spending the time doing this. You can read about the benefits of core aeration to a lawn elsewhere, but it's well documented.

After reading some negative reviews I was a little concerned in buying this tool as it was not cheap. I needn't have worried, it is a great garden tool that is simple yet effective. Firstly it is made from steel bar and not metal tubing so it is sturdy and unlikely to bend, unless subjected to serious abuse. The crossways handle and foot brace both allow for pressure to be applied easily. It is important that the soil be moist to allow for the plugs to be removed whole and to keep the shape of the resultant hole intact. Dry soil that is like solid concrete will be a struggle and overly saturated soil will just be a mud bath! I have used it on both paspalum lawn laid by sod (dense) and zoysia japonica, underlain by red Dubai desert sand. It is very satisfying to quickly extract rows of lawn/soil plugs. The tines do block from time to time and this should be expected due to variations in soil, grass, sod etc. Sometimes applying more force on the next insertion clears the blockage, or rotating 180 degrees for a slightly different angle of attack. Though the instructions indicate to use a large screwdriver or similar tool to unblock, I found that the hosepipe set onto 'jet' was far quicker and less effort, though make sure that you have your gardening clothes on (and goggles for the cautious) as initial blowback water will go in every direction! All in all, very satisfied with this purchase.

Muy resistente. Hay que regar bien el pasto o tierra antes de poder descorazonar. Los agujeros siguen en mi jardín después de 2 semanas y el pasto ha mejorado un poco. Ahora me falta un buen fertilizante para complementar.

Manueel beluchten van het gazon met deze tool werkt uitstekend. Zit zelden verstopt. Prima apparaat.

sehr robust und qualitativ hochwertig. Alles verschweißt und mit Hammerschlagfarbe lackiert weisen auf eine lange Haltbarkeit hin. Auch das Arbeiten geht leicht von der Hand und ich kann hier nur meine Empfehlung aussprechen.

I started to use it a couple days ago, to aerate my backyard(50x60) and my front yard (25x50). After 1 hour, I have completed around 40% of the backyard. I can't wait to get some free time and use it again. I found the product to be easy of use. It's very sturdy and even if not wet it goes easily underground. However, if the lawn is too dry, it may get clogged. It will also get clogged if the lawn is soaking wet. The perfect condition I found was 2-3 days after a good rain. It will at some point get clogged but keep a screwdriver on you and you'll be all right as it's easy to remove the dirt. The holes the product makes are deep and a good size, this will certainly help the lawn grow back. Don't bother to even try to break it....it's very sturdy and it will last for years. Aeration in my city cost around 60 $ so it's already a good investment. The only thing I dislikes is that I'm 6' foot tall and it's a tiny bit small so the back will hurt a bit in the long run. And the knees always hit the metal bar. It's more a problem with how big my lawn is, but someone with a smaller lawn won't feel these issues at all. Overall I'm very satisfied with the product and I recommend it 100%.