One Way Window Privacy Film, Mirror Tint, Black, 17.5In x 6.5Ft | Heat Control & Sun UV Blocking, Static Cling No Glue, Daytime Privacy See Out Not In, Reflective Window Tint for Home Office

We have a bedroom that faces west with a large window. That room is difficult to keep cool in the summer even with the ceiling fan going constantly. Because my cats like to look out that window, I decided to put a one-way privacy film. Because we keep the mini blind up for the cats to look out, figured this would be perfect for privacy. It turned out amazing! You cannot see inside the room at all from outside. It was super easy to install and it even came with a small squeegee and trimmer. The film is thicker than ones I've used in the past so it was easier to keep in place. It adhered perfectly to the window with very few bubbles that were easy to remove. Highly recommend!

DISCLAIMER: I hate what Jeff Bezos is doing to the safety & well-being of his workers and if I lived anywhere with physical stores that stocked supplies like this I’d be thrilled to put money ANYWHERE else. But for those of us in rural areas who need to know about a low-cost product to keep energy costs low, here you go. AFFECT ON TEMP: My kitchen windows are single-pane non-UV glass and it reaches 120°F at the worst point in summers. I’ve applied several window film types in the past elsewhere (anti-shatter, holographic, etc) and this film is by far the easiest to apply. The temperature difference in the kitchen feels like at least 8-10° after covering the windows. AFFECT ON VIEWS/LIGHT: I’m an artist and hyper-specific about color and would hate this if it threw a weird tone onto everything. I got the silver kind, and while it does block a ton of heat, it does not block too much light. There is a slight blue-ish tone to the sunlight compared to before, but it’s calming and doesn’t look fake or fluorescent-like. APPLICATION: 1) Clean your windows multiple times with both vinegar solution and 50/50 rubbing alcohol and water. Think lab-level clean. It really helps. 2) To apply large pieces, use two people. The only annoying thing about this material is that you can crease or put half-moon shape dents in it when unrolling, so it really helps to have a partner or buy extra. Cut to about an inch large on each side but not more. 3) You can use 2 pieces of painters tape on top to hold the piece on, and then peel the inside film off with the window film hanging in position. 4) spray on a lot of barely-soapy water to both the inside of the film AND the window (like half a squirt/tsp of soap in an entire spray bottle) 5) use a rubber squeegee (not included) or a plastic ruler with the edge covered in painters tape to prevent scratching (like I did) to squeegee out bubbles from top to bottom and outwards from the middle towards each side. Pro tip: bumpy terrible windows like my multiple paned ones will likely have remaining bubbles on the sides and that is the fault of the glass, not the film. It’s fine. Perfection is an impossible goal. As for the nice window on the door, that one came out pretty close. One or two tiny half moon dents. Highly recommend, sadly even with the consequences of supporting this late-stage-capitalism death-eater in the process.

Bought this as it is advertised to keep 85% of UB rays out. As someone who lives in the desert but also enjoys keeping my blinds open this was a no brainer purchase. Shopped around for a while and landed on this one. I purchased the silver/silver option. In the larger sizes rolls. I ended up installing on my back glass sliding doors and my side windows. Glass doors - 90 x 27 - x2 Side windows - 56 x 24 - x2 Installation is fairly easy. With the size of my windows I did have an extra hand. As it could be difficult to peel off the backing while trying to apply. After spraying the windows with soapy water and placing it where I wanted it I set it on. I used a blade I bought in a film installation kit on Amazon for like 8$ and it worked like a charm. I would definitely recommend a new blade and a squeegee. The other tool that was a huge help was a ruler. Especially when you are cutting corners and edges. After my cuts and trying my best to perfect it. I. Worked the bubbles out of the film. Occasionally removing the film, respecting the window and re-applying. The bubbles came out fairly easy. Although no matter how much I worked it out there were tiny bubbles that still remain. Please BECAREFUL. This film does scratch easily. I used a squeegee with felt and still managed to scratch parts of it. I have read from a few others that they went away after a while. So if it doesn’t I’ll come back and update my review. The color of the film is silver/silver. I would say it’s pretty close to a one way mirror but you can still see inside if you are close enough. I would say from 5-10 feet away you probably get a 5-10% visibility rate in the middle of the day. If your at the window you can probably see 15-20% of the inside (depending on lighting and time of day). The color of the film has a bit of a tint or very very slight fog from the outside. I don’t know if that’s temporary and will go away. Pros - Easy to Apply Keeps the heat and sun out. But does not block light entirely Value for the price Privacy factor Cons - Slight fog Easily scratches when applying - BECAREFUL when working out bubbles. Creases easily For the price and the amount I received I would recommend it. This is not a paid review. I will be sure to update my review if quality drops off or if it exceeds my expectations.

This works fantastic, to help keep the heat out!! Looks great on our new windows, easy to apply, the tint is great. Think this is going to last a long time! Only thing is not good on privacy at night, fantastic during the day.

Let me start by saying maybe it's me. Or not. My key beefs: * The - very limited - instructions that come with the product make it look dead easy. Don't believe it. * I assume the instructions were a direct translation from Chinese, so they didn't always make sense to me. Not a racist comment: just a fact of life. My wife is Chinese and our kids half Chinese. * No manufacturer's website that I could find. Clips on YouTube provided more info than the manufacturer. * Nowhere do they address any of the issues I detail below or give you any help on how to deal with them. The instructions tell you to clean the window - check. So far, so good. Then you're told to cut the film 10 mm *wider* than the window, but nothing about the length. I'm assuming they meant the length. Lost in translation? Trying to cut the width of the film would make the rest of this a complete nightmare. Next peel the - very thin - protective film covering the actual window film. Okay. Nothing too challenging so far. Now is where it starts to get tricky. "tricky" isn't the right word, but I'm not sure what is. You're told to spray the window with water and then spray the "adhesive" side of the film with water as well. Assuming the window in question is vertical, the water immediately starts running down the glass. Basic high school physics here. Then you're supposed to spray water on the adhesive side of the film as well, but the film rolls itself back into the shape it came in - rolled around a cardboard tube. I don't know how you can possibly spray water onto the film unless you have several people helping you hold the corners down. The drawing on the instruction shows one person apparently "hanging" - that's what it looks like - the film onto the window as if it were a piece of cloth or paper. Which it isn't, and it wants to roll itself back onto its carboard tube. So while you're trying to position it onto the window, it's trying to curl up back into a roll. Eventually I had my wife help me and after several tries we managed to get it positioned more or less correctly. "less" being the operative keyword here. Then you're supposed to put the original protective film back on the actual film, now on the window, so you can push the few bubbles out. "few" on the illustration - your mileage may vary. After pushing as many of the bubbles out as possible, frequently lifting one of the corners to get the larger bubbles out, we have it on the window, albeit with several small "creases", I assume the result of me squeegeeing the bubbles out. Long story short, I didn't find this anything like easy. My recommendation: know what you're getting yourself into, make sure there are 2 of you as you'll need more than your own hands. Read the directions and get everything laid out in advance. Be patient - I'm not, which doesn't help. Actually - hire a professional and watch TV while they struggle. HTH.

Purchased the blue. The view is fine with that color. It does work to reduce the sunlight (I’m sure the black shade would be more effective). The rooms are not too dark. For the price, it’s effective and did seem to reduce the heat absorbed by the afternoon sun and thus helped reduce the cooling costs. Easy enough to hang, but to trim…no. New straight razor, new angled razor, surgical scissors all failed. It cuts ok, but catches so it’s not a clean edge. The second roll didn’t have a right angle was off by an inch or so thus requiring more trimming. The right angle edge was helpful. Learned a couple things-use soapy water mist, not liberally or you just cause more work. Trim to fit, not extra as the directions said. Make a template to cut. After hanging, smooth out some large bubbles, but let dry overnight and then work out the few remaining, otherwise you waste time and the film moves. Amended-ended up ordering the black for garage windows. Not much darker than the blue. Blue definitely provides for a better view. Both definitely block vision from outside during the sunlight hours. After 4 rolls, my biggest complaint is that the film is not all cut evenly, so without a straight edge/angle you have to measure and trim even more. Last roll had a flaw in the film half way through, disappointing after the work to hang the tint. Edit: claims to be reusable and technically it is. But after a summer of direct sun when the film was taken down, its stiffer. Found it best to roll to store. And liable for the window it was used in. Still very stiff when you try to reuse and even with a soapy mist it’s not as self-adhesive as first use and rolled up at the edge. Some bubbles can’t be removed as the stiffness prohibits it from laying flat on the second use. Not a deal breaker.

Renter approved! It's just static cling, super easy to peel off if you mess up or have to move. I didn't cover my entire window since I didn't need to, I only really needed part of it covered, so you can see where the tint begins and ends. The other side is silver and shiny. I can't really see it from outside so I think it works and hopefully isn't too distracting to cars driving by. It's a 6ft roll 17.5" wide. I suggest using soapy water and a credit card to slide out all the air bubbles.

Super easy to use, no trouble installing, First time tinting any sort of window. Does displace heat significantly. So for $7 you will save a ton of money not having to use so much AC or Fans . my apartment in Tijuana was build cheaply so the heat here is bad but these baby’s helped a ton. Now time to tint my Car windows, wish me luck. You also don’t need a fancy kit, just get a squeegee, and some rags and some mild soap.

Pas beaucoup de papier pour le.prix. Merci

I bought this 1.5 years ago for ground level apartment windows. I wanted to enjoy sunlight without worrying about my home being on display for people walking past it. My houseplants (Hoyas and string of hearts) are not affected by lack of sun. Works well on overcast days too. As long as it's brighter outside than inside your home, your privacy is guaranteed. There is a slight tint so on a sunny day it won't be as bright inside but still pleasant. It was very easy to apply. It didn't tear up. I followed the instructions and that was it.

Chegou antes do marcado. Gostei muito. É sútil não fica parecendo que meti um espelho na janela e não dá pra ver nada. Só se meter a cara colada ao vidro. Veio um rolo enorme. Boa quantidade mesmo. Perfeito

Die Spiegelfolie ist seit 6 Wochen an mehreren Fenstern auf der Außenseite angebracht. Es hat seit dem viel geregnet, gestürmt und gehagelt. Die Folie haftet trotzdem anstanslos wie am ersten Tag, obwohl sie nicht verklebt ist sondern nur durch Statik an der Fensterscheibe haftet. Die Anbringen war relativ leicht, die Folie ist stabil und etwas dicker als typische Billigfolien.

مايلصق كويس