B-60545 Impact Gold T25 Torx 2″ Power Bit, 15/Pk

I burn through T25 bits like candy doing renovation work, so I was hunting for something that wouldn’t strip or snap under pressure. These Makita Impact Gold bits have been killer so far. They lock in tight, don’t wobble, and take a beating without twisting off in the driver. I’ve used the same one through a few hundred screws and it’s still sharp. Pros: • Fits snug in impact drivers, no cam-out • Tough enough for pressure-treated lumber • Long 2” length gives good clearance • Comes in a rugged little case Cons: • Case latch is a little cheap, but the bits are solid If you use T25s for framing, fencing, or deck boards, you’ll want this 15-pack in the truck. No junk bits here.

One of the better options on the market. Worth the cost

These bits work great. The fit the torx heads perfectly. They are very well made and showed no degradation after several dozen uses.

I replaced my decking and steps with composite, these bits held up very well, only use one out of the pack. Was skeptical at first, not anymore.

Quality long lasting bits

Great buy and exactly as advertised. Would recommend and fast shipping

Great value and quality

We are building a big deck and went through 85 bits (ok, that’s an exaggeration, but probably actually like 6 or 7) before buying these. The ones that came with the screws would slip and start to wear away very quickly. But after we started using these, we both finished the remainder of the deck with the first bits we put in. They showed a little wear toward the end, but were nowhere near dead. Everything should be made out of this material, forever. 7/5 stars.

Well durable they are

Using to drive #10 x 4" screws into old dry hemlock. Screwed in about 50, not one slip yet and the bit shows very little wear. Will buy again if I ever wear this fifteen out.