GunSkins Gear Skin Compatible with Airsoft AEG - Vinyl 8" x 50" Sheet - Trim to Install - 100% Waterproof Non-Reflective Matte Finish - Made in USA

This has been great. I’ve used this to wrap a 150-600 lens, a camera, a pistol, and still have half of the material left to do some more. It sticks well, it can stretch a little when heated gently all around this is really high quality vinyl wrap for whatever tools you are needing to camouflage.

Not hard to apply and it looks great ( note that a heat gun is required for a real snug fit )

Installs pretty easily, especially with some heat. Adhesive quality was good but I'd make it a bit more sticky if I were king of the world. Haven't used it in the field or shot with it yet. It's holding fine so far. The camo pattern "Edge" is perfect for my hunting area.

Nice skins but they seemed to be slightly thicker than expected. Also I'm not the best at art work so it was a bit difficult for me to apply. Good if you are above average with art skills. Its best if you measure before cutting and cut small pieces for uneven surfaces. Over all a good purchase but it took me some time putting on a scope and ar 10 drum magazine. Almost sure that one packet won't be enough for a whole rifle.

Wrapped my shotgun it turned out perfect

I put this on a Tippman MP2 Striker, it took about three hours to put it on. There was not enough material to complete cover the paintball gun and hopper but it is mostly covered. It dose look good and it does cover smooth and flat surface very good, but round surface are more difficult to keep smooth but take your time and it and can be done

Looks great. There's a bit of a learning curve when learning to apply it, but it's definitely worth the effort. I would recommend it not be applied to areas that rub against something else...like a holster. It's a durable material, but enough rubbing will cause some wear and tear. Despite staying on securely, it is removable with minimal effort, should you decide to change the look. I would recommend this product.

This stuff is great! Put it on a Kel-tec RFB and it adheres nicely to all the plastic parts and stays on metal areas like the scope and even the barrel - after 500 7.62mm rounds in an afternoon there was no noticeable pealing, curling, etc. Do purchase brand new X-Acto blades to cut/shape without pulling off or stretching the skin. Also, don't cut in straight lines; it makes a noticeable seam that draws the eye and detracts for the camo effect. Cut jagged lines and/or follow the curves of the camo pattern and it will all blend nicely without obvious straight "jean seams" that stand out.

Works on all kinds of things from guns scopes stocks bi Knox’s I put that shit on everything lol tuff stuff too

Great product take your time during application check out there youtube videos before for tips

I purchased this product to camouflage a firearm after careful measuring and cutting the package covered a standard size long arm with about 400 sq cm left over. The thickness indicates very good durability for rough use and protection. The colours absolutely pop and the kryptex pattern works as intended