SEAFLO 33-Series Water Pump and Accumulator Tank System - 12V DC, 3.0 GPM, 45 PSI, 0.2 Gallon Tank

Excellent piece of kit used it to replace a Jabsco setup it’s now more powerful quieter & also a lot cheaper very happy

This is a brilliant piece of kit for a campervan conversion

What a great product had problems with my water now for 2 years noisy pump poor supply then I found this on here great piece of kit worked straight away and quiet I have tried loads of punmps but this is the best and it comes built up just connect neg and positive and water and that's it

Caused a water hammer issue on low pressure side 🥴 I fixed with an arrestor valve so all good

Horrified that the pump has lasted for three months and the pump has now failed . Made a lot of noise in the last two days and stopped . No obvious reason and been checked over so absolutely furious . Unfortunately cannot recommend the purchase of this .

Quieter than the Surflo water pump that was OEM to my camper. The flow of water is now a consistent flow instead of changing rate of flow. My tankless water heater runs better with this new pump with accumulator installed. I can get 2 hot showers before emptying my freshwater tank. This is my backup for when my city water hookup has too low of pressure for the water heater to work properly.

Bien

Love this combo unit . It's a nice tight bit of kit that makes installation and upgrading to a pump/accumulator system rather than just a pump. I will buy it again if needed.

The combo pump&tank fit well on my boat. Replaced a 3.5 GPM pump and this one seems to generate better pressure than the last one. It is very quiet and seems to cycle less often.

Overall I like this upgrade. The only issue I had with mine is that the pressure switch seemed to be set too high. When I first installed it, I switched it on started testing things. Everything was going good, so I left the pump on to see if I had any leaks for a while. I came back about an hour later and I couldn't touch the pump it was so hot. It also wouldn't run at that point when I turned on a faucet. It turned out that the pressure switch was set too high, and even 12 volts from the converter in my RV couldn't supply enough juice over 12a WG wire to satisfy that switch. Unfortunately I had already mounted and completely connected the pump, and I had situated it so that the pressure switch adjustment screw was facing a wall. After some adjustment, the unit works fine, and I found out that it wasn't running because of a thermal cut off. I just let it cool down and everything is good. The install was quick and easy. The pump on the board is much larger than just the pump that came in my rv, but I locked out that it fit perfectly on the floor inside the cabinet that the original pump was mounted in. Thanks to the additional connectors that were all included, I was able to shorten and properly connect the inlet and outlet without any modifications to the RV. I line the inside of the cabinet at this pump is mounted in with butyl rubber. Together with the rubber feet on the mounting platform, and the fact that it's just a quieter pump to begin with, the water pump has gone from something that will wake you up in the middle of the night to something that you strain to hear. Really nice upgrade