Antrader RG58 3 Feet 50-Ohm BNC Male to BNC Male Coaxial Cable Pack of 10

Totally out of spec. Difficult to connect and then makes for loose connections. When these first arrived I gave them a good review because I pulled one out of the package and carefully tested it. Wouldn't you know, that was the one and only of these units that did not give me trouble. Then a week later, I discovered that all the rest of the other nine were crap. Goes to show you, you can't be too careful before writing a good review. Back they go. KC3BKJ

Ran continuity tests on all 10 with NO shorts or opens. Well-made, Coax and BNC Connecters, and would buy again.

I am using these with my oscilloscope and function generator. They work great for my usage. Note that I am working with pretty low frequency signals. I am not sure how well they work with higher frequencies. But if you are just looking at signals below 1MHz like control signals from an Arduino, etc then they do the job.

90 % of the units received failed with in the first 30 days of use unable to return. Poor quality and reliability several were bad out of the box open center tap . The others failed by shorting to the shield

They worked out of several trys these worked

Look good. Seem well made. No way to measure RF characteristics.

Used for my security system.

Great product

Bien,

Se observa que no son flexibles. Apenas los voy a usar, ya después doy una opinión más exacta de calidad.

They're here in no time and no problems connecting him they work very good thank you very much

Two of three cables are defective. to make things more terrible, vendor doesn't allow to return.